User manual MAKITA RST250 REMPLACEMENT PARTS

[. . . ] This will assist you to obtain the best possible result from your MAKITA String Trimmer. You will note the following symbols when reading the instruction manual. Keep the area of operation clear of other persons and pets Wear eye and ear protection ­ To ensure correct operation, user has to read this instruction manual to make himself familiar with the handling of the string trimmer. Users insufficiently informed will risk danger to themselves as well as others due to improper handling. [. . . ] ­ Only use the string trimmer in good lighting and visibility. During the winter season beware of slippery or wet areas, ice and snow (risk of slipping). ­ Never climb up trees to perform cutting operation with the string trimmer. Foreign particles may damage the nylon cutting head and can cause dangerous kick-backs. ­ Before commencing cutting, the nylon cutting head must have reached full working speed. Employ only the correct nylon cutting head for the job in hand. Perform this cutting work by swinging the string trimmer evenly in half-circles from right to left (similar to using a scythe). ­ The condition of the trimmer also of the shoulder strap must be checked before commencing work. ­ Turn off the engine and remove the spark plug connector when replacing, and also when cleaning the nylon cutting head. ­ Operate the string trimmer with as little noise and contamination as possible. ­ Always store the string trimmer in locked rooms and with an emptied fuel tank. ­ If the nylon cutting head hits against a stone during operation, stop the engine and check the nylon cutting head immediately. Turn the machine upside down, and you can replace the nylon cutting head. ­ Insert the hex wrench provided through the hole in the head case and rotate the support washer until it is locked with the hex wrench (or the shaft is locked). Handling fuel Utmost care is required when handling fuel. fuel may contain substances similar to solvents. Refuel either in a well-ventilated room or outdoors. Do not inhale fuel vapors; avoid any contact of fuel or oil with your skin. Mineral oil products degrease your skin. If your skin comes in contact with these substances repeatedly and for an extended period of time, it will desiccate. in addition , allergic reactions mey occur. Eyes can be irritated by contact with oil. [. . . ] Clogging of the element (1) may sometimes make it difficult or impossible to start up the engine or increase the engine speed. After the end of operation, be sure to clean the air cleaner as mentioned below. ⭠Remove the air cleaner cover screw. ­ Place the finger under the air cleaner cover, push down the cover lower part, and detach the air cleaner cover. [. . . ]