User manual MAKITA RT0700C

[. . . ] /II • Due to the continuing program of research and development, the specifications herein are subject to change without prior notice. €¢ Specifications may differ from country to country. €¢ Weight according to EPTA-Procedure 01/2003 ENE010-1 GEA010-1 General Power Tool Safety Warnings WARNING Read all safety warnings and all instructions. Failure to follow the warnings and instructions may result in electric shock, fire and/or serious injury. [. . . ] 17 for cutting circles between 121 mm and 221 mm in radius. NOTE: • Circles between 172 mm and 186 mm in radius cannot be cut using this guide. Drive a nail less than 6 mm in diameter into the centre hole to secure the straight guide. Pivot the tool around the nail in clockwise direction. 18) Trimmer guide (optional accessory) Trimming, curved cuts in veneers for furniture and the like can be done easily with the trimmer guide. The guide roller rides the curve and assures a fine cut. 19) Install the trimmer guide on the tool base with the clamp screw (A). Loosen the clamp screw (B) and adjust the distance between the bit and the trimmer guide by turning the adjusting screw (1 mm per turn). At the desired distance, tighten the clamp screw (B) to secure the trimmer guide in place. 20) When cutting, move the tool with the guide roller riding the side of the workpiece. 21) Templet guide The templet guide provides a sleeve through which the bit passes, allowing use of the trimmer with templet patterns. 9) Loosen the screws and remove the base protector. Place the templet guide on the base and replace the base protector. Then secure the base protector by tightening the screws. 10) Secure the templet to the workpiece. Place the tool on the templet and move the tool with the templet guide sliding along the side of the templet. 11) NOTE: • The workpiece will be cut a slightly different size from the templet. Allow for the distance (X) between the router bit and the outside of the templet guide. The distance (X) can be calculated by using the following equation: Distance (X) = (outside diameter of the templet guide – router bit diameter) / 2 Tilt base (optional accessory) Tilt base (optional accessory) is convenient for chamfering. 22) Place the tool onto the tilt base and close the locking lever at the desired protrusion of the bit. For desired angle, tighten the clamping screws on its sides. Firmly clamp a straight board to the workpiece and use it as a guide against the trimmer base. [. . . ] 47) Secure the templet to the workpiece. Place the tool on the templet and move the tool with the templet guide sliding along the side of the templet. 48) NOTE: • The workpiece will be cut a slightly different size from the templet. Allow for the distance (X) between the bit and the outside of the templet guide. [. . . ]