User manual MAKITA SA7000

[. . . ] Be sure that you understand their meaning before use. 1 2 3 4 5 Shaft lock Lock lever Switch trigger Lock nut Abrasive disc 6 7 8 9 10 Rubber pad Lock nut wrench Shaft lock Exhaust vent Inhalation vent 2. Due to our continuing program of research and development, the specifications herein are subject to change without notice. â· Note: Specifications may differ from country to country. [. . . ] Always use auxiliary handle, if provided, for maximum control over kickback or torque reaction during startup. The operator can control torque reactions or kickback forces, if proper precautions are taken. B) Never place your hand near the rotating accessory. C) Do not position your body in the area where power tool will move if kickback occurs. kickback will propel the tool in direction opposite to the wheel's movement at the point of snagging. D) Use special care when working corners, sharp edges etc. E) Do not attach a saw chain woodcarving blade or toothed saw blade. Follow manufacturers recommendations, when selecting sanding paper. Larger sanding paper extending beyond the sanding pad presents a laceration hazard and may cause snagging, tearing of the disc or kickback. Accessories must be rated for at least the speed recommended on the tool warning label. Wheels and other accessories running over rated speed can fly apart and cause injury. Maximum operating speed of accessories should be higher than the highest no load speed marked on the tool's nameplate. Ordinary eye or sun glasses are NOT safety glasses. Check the backing pad carefully for cracks, damage or deformity before operation. NEVER use tool with wood cutting blades or other sawblades. Such blades when used on a sander frequently kick and cause loss of control leading to personal injury. Make sure the abrasive disc is not contacting the workpiece before the switch is turned on. When sanding metal surfaces, watch out for flying sparks. Hold the tool so that sparks fly away from you and other persons or flammable materials. Do not touch the workpiece immediately after operation; it may be extremely hot and could burn your skin. Pay attention that the wheel continues to rotate after the tool is switched off. This tool has not been waterproofed, so do not use water on the workpiece surface. [. . . ] For tool with the lock-off switch To prevent the switch trigger from accidentally pulled, a lock lever is provided. To start the tool, push in the lock lever and then pull the switch trigger. For tool with the lock on and lock-off switch To prevent the switch trigger from accidentally pulled, a lock lever is provided. To start the tool, push in the lock lever and then pull the switch trigger. [. . . ]