User manual MAKITA SC130DRA

[. . . ] Symbols The following show the symbols used for the tool. Be sure that you understand their meaning before use. [ Do not discard batteries into garbage can or the like. Note: The recycling method may differ from country to country, or state (province) to state (province). [. . . ] If the cartridge does not slide in easily, it is not being inserted correctly. The charging light will flash in green color. Insert the battery cartridge so that the plus and minus terminals on the battery cartridge are on the same sides as their respective markings on the fast charger. insert the cartridge fully into the port so that it rests on the charger port floor. When the battery cartridge is inserted, the charging light color will change from green to red and charging will begin. The charging light will remain lit steadily during charging. When charging is completed, the charging light color will change from red to green and tone will sound steadily for about 5 seconds. After charging, unplug the charger from the power source. The charging light will flash in green color. Insert the battery cartridge so that the plus and minus terminals on the battery cartridge are on the same sides as their respective markings on the battery charger. When the battery cartridge is inserted, the charging light color will change from green to red and charging will begin. The charging light will keep lighting up steadily during charging. When charging is completed, the charging light color will change from red to green. After charging, unplug the charger from the power source. Never use it for other purposes or for other manufacturer's batteries. â· When you charge a new battery cartridge or a battery cartridge which has not been used for a long period of time, it may not accept a full charge. This is a normal condition and does not indicate a problem. You can recharge the battery cartridge fully after discharging it completely and recharging a couple of times. â· If you charge a battery cartridge from a just-operated tool or a battery cartridge which has been left in a location exposed to direct sunlight or heat for a long time, the charging light may flash in red color. If the charging light flashes alternately in green and red color and tone will sound ``beep, beep, beep, . '' for about 20 seconds, a problem exists and charging is not possible. The terminals on the charger or battery cartridge are clogged with dust or the battery cartridge is worn out or damaged. [. . . ] In that case, use the hex wrench M4 to release the hydraulic pressure in the return valve. Insert the hex wrench M4 into the return valve hole and make a half turn in the counterclockwise direction. This releases the hydraulic pressure inside the tool, allowing the cutter rod to return to its initial position. Always retighten the valve before doing the next cut-off job. [. . . ]