User manual MAKITA SG150

[. . . ] Be sure that you understand their meaning before use. . . . . . . . . . . . . . . . . . . . Read instruction manual. . . . . . . . . . . . . . . . . . . . DOUBLE INSULATION . . . . . . . . . . . . . . . . . . . . . Wear safety glasses. . . . . . . . . . . . . . . . . . . Only for EU countries Do not dispose of electric equipment together with household waste material! [. . . ] Do not expose power tools to rain or wet conditions. Water entering a power tool will increase the risk of electric shock. Never use the cord for carrying, pulling or unplugging the power tool. Keep cord away from heat, oil, sharp edges or moving parts. Damaged or entangled cords increase the risk of electric shock. When operating a power tool outdoors, use an extension cord suitable for outdoor use. Use of a cord suitable for outdoor use reduces the risk of electric shock. Stay alert, watch what you are doing and use common sense when operating a power tool. Do not use a power tool while you are tired or under the influence of drugs, alcohol or medication. A moment of inattention while operating power tools may result in serious personal injury. Safety equipment such as dust mask, non-skid safety shoes, hard hat, or hearing protection used 3 20. Be careful not to damage the spindle, flanges (especially the installing surface) or bolt. Damage to these parts could result in wheel breakage. Make sure the wheel is not contacting the workpiece before the switch is turned on. Wait until the wheel attains full speed before cutting. Stop operation immediately if you notice anything abnormal. Never attempt to cut with the tool held upside down in a vise. This can lead to serious accidents, because it is extremely dangerous. Before setting the tool down after completing a cut, be sure that the wheel has come to a complete stop. Do not stop the wheel by lateral pressure on the disc. The tool must be used only for dry cutting. 8. 9. SAVE THESE INSTRUCTIONS 4 FUNCTIONAL DESCRIPTION · CAUTION: Always be sure that the tool is switched off and unplugged before adjusting or checking function on the tool. 004496 Shaft lock CAUTION: Never actuate the shaft lock when the spindle is moving. [. . . ] Rotate the diamond wheel while pressing the shaft lock until it engages. Remove the lock nut by rotating it counterclockwise with the lock nut wrench. Remove the diamond wheel and space rings. 1 2 1. Lock nut wrench 7 Adjusting the groove width (the distance between the two diamond wheels) The width of grooving in the workpiece can be adjusted by changing the number of the space rings as shown in the table. 004503 Groove width: 30 mm Groove width: 27 mm Groove width: 24 mm 1 4 2 3 5 Groove width: 21 mm Groove width: 18 mm Groove width: 15 mm Groove width: 12 mm Groove width: 9 mm Groove width: 6 mm 1. [. . . ]