User manual MAKITA TD021D

[. . . ] the battery cartridge can explode in a fire. Be careful not to drop or strike battery. Due to our continuing program of research and development, the specifications herein are subject to change without notice. ⷠSpecifications and battery cartridge may differ from country to country. [. . . ] Before inserting the battery cartridge into the tool, always check to see that the switch actuates properly and returns to the "OFF" position when released. To start the tool, first move the lock lever to the unlocked position to release the switch lever. Always check the direction of rotation before operation. ⷠChange the direction only after the tool comes to a complete stop. Changing the direction of rotation before the tool stops may damage the tool. ⷠWhen not operating the tool, always set the lock lever in the locked position . To install the bit, pull the sleeve in the direction of the arrow and insert the bit into the sleeve as far as it will go. 7) To install the bit, pull the sleeve in the direction of the arrow and insert the bit-piece and bit into the sleeve as far as it will go. The bit-piece should be inserted into the sleeve with its pointed end facing in. To remove the bit, pull the sleeve in the direction of the arrow and pull the bit out firmly. nOTE: · If the bit is not inserted deep enough into the sleeve, the sleeve will not return to its original position and the bit will not be secured. In this case, try re-inserting the bit according to the instructions above. The tool can be used in two ways; a straight type and a pistol type which is selectable according to the conditions of workplace and screwdriving. When bending the tool to use in the pistol type or straightening to use in the straight type, do not hold the bendable part of the tool. Failure to do so may cause your hand and fingers to be pinched and injured by this part. hold the tool firmly and place the point of the driver bit in the screw head. Apply forward pressure to the tool to the extent that the bit will not slip off the screw and turn the tool on to start operation. The proper fastening torque may differ depending upon the kind or size of the screw/bolt, the material of the workpiece to be fastened, etc. Do not look in the light or see the source of light directly. To start the tool, first move the lock lever to the released position to release the switch. 5) To put on the light only, rotate the switch to the A or B side a little. To not only put on the light but also start the tool rotate the switch to the A or B side more. [. . . ] We Makita Corporation as the responsible manufacturer declare that the following Makita machine(s): Designation of Machine: Cordless Impact Driver Model No. / Type: TD021D are of series production and Conforms to the following European Directives: 98/37/EC until 28th December 2009 and then with 2006/ 42/EC from 29th December 2009 And are manufactured in accordance with the following standards or standardised documents: EN60745 The technical documentation is kept by our authorized representative in Europe who is: Makita International Europe Ltd. Always be sure that the tool is switched off and the battery cartridge is removed before attempting to perform inspection or maintenance. To maintain product SAFETY and RELIABILITY, repairs, any other maintenance or adjustment should be performed by Makita Authorized Service Centers, always using Makita replacement parts. [. . . ]