User manual MAKITA TM3000C

[. . . ] Do not operate the tool at no-load unnecessarily. Some material contains chemicals which may be toxic. Take caution to prevent dust inhalation and skin contact. This tool has not been waterproofed, so do not use water on the workpiece surface. [. . . ] Using water or other liquid coolants may result in electrocution or shock. Always be sure that the tool is switched off and unplugged before carrying out any work on the tool. If working place is extremely hot and humid, or badly polluted by conductive dust, use a shortcircuit breaker (30 mA) to assure operator safety. Be sure no one is below when using the tool in high locations. 1) CAUTION: • Before plugging in the tool, always check to see that the tool is switched off. To start the tool, slide the slide switch toward the “I (ON)” position. To stop the tool, slide the slide switch toward the “O (OFF)” position. To change the orbital stroke rate, turn the dial between 1 and 5. The higher the number is, the higher the orbital stroke rate is. Preset the dial to the number suitable for your workpiece. NOTE: • The dial cannot be turned directly from 1 to 5 or from 5 to 1. When changing the dial direction, always turn the dial moving it through each intermediate number. Constant speed control Electronic speed control for obtaining constant speed. Possible to get fine finish, because the orbital stroke rate is kept constant even under load condition. ASSEMBLY CAUTION: • Always be sure that the tool is switched off and unplugged before carrying out any work on the tool. Installing application tool upside down may damage the tool and cause serious personal injury. €¢ Install attachment tool in the correct direction according to your work. Application tool can be installed at an angle of every 30 degree. Put an application tool (optional accessory) on the tool flange so that the protrusions of the tool flange fit in the holes in the application tool and secure the application tool by tightening the bolt firmly with the hex wrench. As sanding papers have holes for dust extraction, mount a sanding paper so that the holes in a sanding paper match those in the sanding pad. To remove a sanding paper, raise its end and peel it off. Loosen and remove the application tool installation bolt using a hex wrench and then take off the application tool. [. . . ] To maintain product SAFETY and RELIABILITY, repairs, carbon brush inspection and replacement, any other maintenance or adjustment should be performed by Makita Authorized Service Centers, always using Makita replacement parts. 5 m/s2 Work mode: Cutting with plunge cut saw blade Vibration emission (ah): 6. 5 m/s2 Work mode: Cutting with segmental saw blade Vibration emission (ah): 3. 5 m/s2 ENG901-1 • The declared vibration emission value has been measured in accordance with the standard test method and may be used for comparing one tool with another. [. . . ]