User manual MAKITA TW0250

[. . . ] WARNING: DO NOT let comfort or familiarity with product (gained from repeated use) replace strict adherence to safety rules for the subject product. MISUSE or failure to follow the safety rules stated in this instruction manual may cause serious personal injury. Always be sure that the tool is switched off and unplugged before adjusting or checking function on the tool. Before plugging in the tool, always check to see that the switch trigger actuates properly and returns to the "OFF" position when released. [. . . ] Be sure no one is below when using the tool in high locations. Always be sure that the tool is switched off and unplugged before carrying out any work on the tool. Always use the correct size socket for bolts and nuts. Always be sure that the tool is switched off and unplugged before installing or removing the socket. 3) To install the socket, push it onto the anvil of the tool until it locks into place. 4) Move the O-ring out of the groove in the socket and remove the pin from the socket. Fit the socket onto the anvil of the tool so that the hole in the socket is aligned with the hole in the anvil. This can be removed without using a tool. This can be installed on either side of the tool. Even though the torque coefficient and the class of bolt are the same, the proper fastening torque will differ according to the diameter of the bolt. ⷠEven though the diameters of bolts are the same, the proper fastening torque will differ according to the torque coefficient, the class of bolt and the bolt length. The manner of holding the tool or the material of driving position to be fastened will affect the torque. Always be sure that the tool is switched off and unplugged before attempting to perform inspection or maintenance. Hold the tool only by the handle when performing an operation. 6) The proper fastening torque may differ depending upon the kind or size of the bolt, the material of the workpiece to be fastened, etc. Turn the tool on and fasten for the proper fastening time. nOTE: · When fastening screw M10 or smaller, carefully adjust pressure on the switch so that the screw is not damaged. ⷠHold the tool pointed straight at the bolt or nut without applying excessive pressure on the tool. ⷠIf you fasten the bolt for a time longer than shown in the figures, the bolt or the socket may be overstressed, damaged, etc. Before starting your job, always perform a test operation to determine the proper fastening time for your bolt. [. . . ] Noise The typical A-weighted noise level determined according to EN60745: Sound pressure level (LpA): 93 dB (A) Sound power level (LWA): 104 dB (A) Uncertainty (K): 3 dB (A) Wear ear protection The declared vibration emission value has been measured in accordance with the standard test method and may be used for comparing one tool with another. ⷠThe declared vibration emission value may also be used in a preliminary assessment of exposure. wARNING: · The vibration emission during actual use of the power tool can differ from the declared emission value depending on the ways in which the tool is used. ⷠBe sure to identify safety measures to protect the operator that are based on an estimation of exposure in the actual conditions of use (taking account of all parts of the operating cycle such as the times when the tool is switched off and when it is running idle in addition to the trigger time). [. . . ]