User manual MAKITA UC250D

[. . . ] Be sure that you understand their meaning before use. 12 • Hold the saw with both hands while working!ς αλυσίδας αλυσοπρίονου Cd Ni-MH Li-ion • Only for EU countries Do not dispose of electric equipment or battery pack together with household waste material!In observance of European Directive 2002/96/EC on waste electric and electronic equipment, 2006/ 66/EC on batteries and accumulators and waste batteries and accumulators and their implementation in accordance with national laws, electric equipment and battery pack that have reached the end of their life must be collected separately and returned to an environmentally compatible recycling facility. [. . . ] The indicator lamps will then light for approx. At this time, fit the saw chain as shown in the figure because it rotates in the direction of arrow. To refill the tank, remove the cap from the oil tank opening. After refilling the tank, always screw the provided oil tank cap on the chain saw. The oil delivery may otherwise be impaired. €¢ As a saw chain oil, use oil exclusively for Makita chain saws or oil available in market. • Never use oil including dust and particles or volatile oil. €¢ When pruning trees, use botanical oil. €¢ Never force the chain saw when pruning trees. €¢ Before cutting out, make sure that the provided oil tank cap is screwed in place. Start it and wait until lubrication on saw chain is adequate. Bring the lower guide into contact with the branch to be cut before switching on. Cutting without bringing the lower guide into contact with the branch may cause the guide bar to wobble, resulting in injury to operator. Saw the wood to be cut by just moving it down. 18 & 19) CAUTION: • Before using battery adapter, read all instructions on tools using battery. €¢ When charging a battery cartridge, first remove it from the battery adapter and then charge it. It is not allowed to charge the battery cartridge while using battery adapter. Installing or removing battery adapter • Always switch off the tool before insertion or removal of the battery adapter. €¢ To remove the battery adapter, slide it from the tool while sliding the button on the adapter. €¢ To install the battery adapter, align the tongue on the battery adapter with the groove in the housing and slip it into place. Insert it all the way until it locks in place with a little click. 22) Battery adapter (Accessory) (Fig. [. . . ] Keep the carbon brushes clean and free to slip in the holders. Both carbon brushes should be replaced at the same time. Use a screwdriver to remove the brush holder caps. Take out the worn carbon brushes, insert the new ones and secure the brush holder caps. [. . . ]