User manual MAKITA UH200D

[. . . ] Battery cartridge Button Lock-off button Switch trigger Indication lamp Trimming direction Tilt the blades Hedge surface to be trimmed String Clamping nuts Chip receiver Screws on the shear blades Blade cover to be always installed before installing the chip receiver 14. Machine oil Blade cover Undercover Locking lever Press Turn Screws Crank Shear blades Basic alignment line on the tool housing Pins Apply grease. Model Blade length Strokes per minute (min-1) Overall length Net weight Rated voltage UH200D 200 mm 1, 250 460 mm 1. Due to our continuing programme of research and development, the specifications herein are subject to change without notice. [. . . ] The condition of the equipment, in particular of the cutting tool of the protective devices must be checked before commencing work. Turn off the motor and remove the battery cartridge before carrying out maintenance, replacing cutting tools or cleaning the equipment or cutting tool. Check loose fasteners and damaged parts such as cracks in the cutting attachment. When not in use, store the equipment indoors in dry and high or locked-up place - out of the reach of children. Use only the manufacturer's recommended replacement parts and accessories. Have the equipment repaired only by our authorized service center. Keep handles dry, clean and free from oil and grease. WARNING: DO NOT let comfort or familiarity with product (gained from repeated use) replace strict adherence to safety rules for the subject product. Follow the safety rules stated in this instruction manual may cause serious personal injury. Always be sure that the tool is switched off and the battery cartridge is removed before adjusting or checking function on the tool. Before using battery cartridge, read all instructions and cautionary markings on (1) battery charger, (2) battery, and (3) product using battery. It may result in a risk of overheating, possible burns and even an explosion. If electrolyte gets into your eyes, rinse them out with clear water and seek medical attention right away. Do not short the battery cartridge: (1) Do not touch the terminals with any conductive material. A battery short can cause a large current flow, overheating, possible burns and even a breakdown. Do not store the tool and battery cartridge in locations where the temperature may reach or exceed 50°C (122°F). Do not incinerate the battery cartridge even if it is severely damaged or is completely worn out. Be careful not to drop or strike battery. Always switch off the tool before insertion or removal of the battery cartridge. ⷠTo remove the battery cartridge, withdraw it from the tool while pressing the buttons on both sides of the cartridge. ⷠTo insert the battery cartridge, hold it so that the battery cartridge front shape fits to that of the battery installment opening and slip it into place. Always insert it all the way until it locks in place with a little click. [. . . ] cAUTION: · Smear the blade before and once per hour during operation using machine oil or similars. When operating the tool, be careful of your physical conditions. 49) Turn the tool on after adjusting the shearing height and hold it so that the foot of the tool rest on the ground. Then gently move the tool forward into the area to be cut. [. . . ]