User manual MAKITA UH4030

[. . . ] Read this instruction manual carefully before putting the hedge trimmer into operation and strictly observe the safety regulations!We are confident that you will be satisfied with this modern machine. Models UH 4030, UH 4830, UH 5530 and UH 6330 are very light and handy hedge trimmers, with high performance and a good power-to-weight ratio. The ergonomic design of the grips and controls make for comfortable and untiring operation during extensive jobs. [. . . ] Lightly oil the cutter and put on the sheath. The sheath supplied with the unit can be hung on the wall, providing a safe and practical way to store the hedge trimmer. Switch off the trimmer and disconnect and secure the mains plug before doing any maintenance work. Make especially sure the cutter is undamaged and in good condition. Use only splash-proof extension cords that are approved for outdoor use and marked as such. when selecting an extension cord , give preference to cords in fluorescent or eye-catching colours. The hedge trimmer is protectively insulated in accordance with VDE (German Electricians´ Association) Standard 0740 Class II, and can therefore be connected to plug sockets without ground contact. Always work in such a way that the extension power cord is behind you!Always start near the power source and work away from it. This ensures that the extension cord stays behind the work area. The trimmer power cord must likewise always be behind the operator. Make sure that it does not get caught, or comes into contact with sharp objects. Route the cord in such a way that no persons can be endangered. Follow the accident-prevention instructions and recommendations of your trade association or insurer. Do not make any modifications to the hedge trimmer. Doing so will only endanger your safety. Perform only the maintenance and repair works described in the instruction manual. All other work must be carried out by MAKITA Service. Use only original MAKITA spare parts and accessories. Using other than original MAKITA parts or accessories brings a high risk of accidents. We cannot accept any responsibility for accidents and damage resulting from nonMAKITA parts and accesories which have not been approved. Important: Work especially carefully when the extension cord has to be routed over the hedge! [. . . ] 3 Round off the top edges of the hedge (3), and finally trim the bottom edges back somewhat (4). 4 The best times to trim hedges are: Broad-leaf hedges: Coniferous hedges: Fast-growing hedges: June and October April and August About every 6 weeks starting in May Do not use the hedge trimmer during times when people are likely to be resting. Before trimming a hedge, check to make sure that no birds are nesting in it. If they are, wait until the young have left the nest before trimming near that part of the hedge. [. . . ]