User manual MAKITA UH4860

[. . . ] Chip receiver Nut Shear blade Hooks Fit the hooks into hole Holes Press the hooks on both sides Unlock the hooks Model Blade length Strokes per minute (min-1) Overall length Net weight Safety class UH4260 420 mm 1, 600 821 mm 2. Due to our continuing programme of research and development, the specifications herein are subject to change without notice. ⷠNote: Specifications may differ from country to country. END220-2 Symbols The following show the symbols used for the equipment. [. . . ] Keep all parts of the body away from the cutter blade. Do not remove cut material or hold material to be cut when blades are moving. Make sure the switch is off when clearing jammed material. A moment of inattention while operating the hedge trimmer may result in serious personal injury. Carry the hedge trimmer by the handle with the cutter blade stopped. When transporting or storing the hedge trimmer always fit the cutting device cover. Proper handling of the hedge trimmer will reduce possible personal injury from the cutter blades. During operation the cable may be hidden in shrubs and can be accidentally cut by the blade. Do not use the hedge trimmer in the rain or in wet or very damp conditions. First-time users should have an experienced hedge trimmer user show them how to use the trimmer. The hedge trimmer must not be used by children or young persons under 18 years of age. Young persons over 16 years of age may be exempted from this restriction if they are undergoing training under the supervision of an expert. Use the hedge trimmer only if you are in good physical condition. If you are tired, your attention will be reduced. Be especially careful at the end of a working day. The user is responsible for all damages to third parties. Never use the trimmer when under the influence of alcohol, drugs or medication. Check to make sure that the voltage and frequency of the power supply correspond to the specifications given on the identification plate. We recommend the use of a residual-current-operated circuit breaker (ground-fault circuit interrupter) with a tripping current of 30 mA or less, or an earth leakage current protector. Work gloves of stout leather are part of the basic equipment of the hedge trimmer and must always be worn when working with it. Also wear sturdy shoes with anti-skid soles. Before starting work check to make sure that the trimmer is in good and safe working order. [. . . ] 14) Trim boxwood or rhododendron from the base toward the top for a nice appearance and good job. Always be sure that the tool is switched off and unplugged before installing or removing chip receiver. nOTE: · When replacing the chip receiver, always wear gloves so that hands and face does not directly contact the blade. Always be sure to remove the blade cover before installing the chip receiver. [. . . ]