User manual MAKITA UH550D

[. . . ] String Press Chip receiver Nut Shear blade Branch catcher Hooks Fit the hooks into groove 31. Grooves Press the levers on both sides Unlock the hooks Blade cover Screws Under cover Plate Crank Oval hole of shear blade Limit mark Holder cap cover Screwdriver Brush holder cap SPECIFICATIONS Model Blade length Strokes per minute (min-1) Overall length Net weight Rated voltage 1, 070 mm 5. 36V UH550D BUH650 650 mm 1, 000 - 1, 800 1, 154 mm UH650D • Due to our continuing program of research and development, the specifications herein are subject to change without notice. €¢ Specifications and battery cartridge may differ from country to country. [. . . ] The handle will be locked in 90° position. CAUTION: • Always make sure that the handle is locked in the desired position before operation. Switch action CAUTION: • Before inserting the battery cartridge into the tool, always check to see that the switch trigger actuates properly and returns to the “OFF” position when released. 3) For your safety, this tool is equipped with a dual switching system. To turn on the tool, press triggers A and B. Release either one of the two pressed triggers to turn off. The sequence of switching is unimportant as the tool only starts when both switches are activated. Battery remaining capacity indicator (only for models with Battery BL3622A) Battery BL3622A is equipped with the battery remaining capacity indicator. 5) Press the CHECK button to indicate the battery remaining capacity. The indicator lamps will then light for approx. 4) The strokes per minute can be adjusted just by turning the adjusting dial. This can be done even while the tool is running. 011713 may accidentally fall out of the tool, causing injury to you or someone around you. €¢ Do not use force when inserting the battery adapter. If the adapter does not slide in easily, it is not being inserted correctly. €¢ The way of removing or installing a battery cartridge from or on the battery adapter is the same as that of removing or installing it from or on the tools. €¢ Press down the hook securely as far as it will go when the battery adapter is hooked on the waist belt and similar objects. Arm cord hook (Accessory) CAUTION: • Do not attach the holder of arm cord hook to other than the extension cord. failure to do so may cause an accident or personal injury. Using the arm cord hook helps to minimize a risk of cutting off the extension cord unexpectedly caused by the loose extension cord. 8) Attach firmly the arm cord hook band placing around your arm and pass the extension cord through the holder. The length of the arm cord hook band is adjustable. [. . . ] Both carbon brushes should be replaced at the same time. 31) Insert the top end of slotted bit screwdriver into the notch in the tool and remove the holder cap cover by lifting it up. Take out the worn carbon brushes, insert the new ones and secure the brush holder caps. Reinstall the holder cap cover on the tool. [. . . ]