User manual MAKITA UH5580

[. . . ] Grooves Press the hooks on both sides Unlock the hooks Screws Blade cover Under cover Gear housing cover Crank Ellipse of shear blade Model Blade length Strokes per minute (min-1) Overall length Net weight Safety class UH5580 550 mm 1, 500 970 mm 4. Due to our continuing programme of research and development, the specifications herein are subject to change without notice. â· Note: Specifications may differ from country to country. END220-1 Symbols The following show the symbols used for the equipment. [. . . ] If you are tired, your attention will be reduced. Be especially careful at the end of a working day. The user is responsible for all damages to third parties. Never use the trimmer when under the influence of alcohol, drugs or medication. Check to make sure that the voltage and frequency of the power supply correspond to the specifications given on the identification plate. We recommend the use of a residual-current-operated circuit breaker (ground-fault circuit interrupter) with a tripping current of 30 mA or less, or an earth leakage current protector. Work gloves of stout leather are part of the basic equipment of the hedge trimmer and must always be worn when working with it. Also wear sturdy shoes with anti-skid soles. Before starting work check to make sure that the trimmer is in good and safe working order. Check cable for damage before starting work and replace if necessary. The hedge trimmer must not be used unless fully assembled. Always work in such a way that the extension power cord is behind you. Remove plug from the mains immediately if cable is damaged or cut. Make sure you have a secure footing before starting operation. Immediately switch off the motor and unplug the mains plug if the cutter should come into contact with a fence or other hard object. Before checking the cutter, taking care of faults, or removing material caught in the cutter, always switch off the trimmer and unplug the mains plug. Switch off the trimmer and disconnect and secure the mains plug before doing any maintenance work. When moving the hedge trimmer to another location, including during work, always unplug the mains plug. Never carry or transport the trimmer with the cutter running. Clean the hedge trimmer and especially the cutter after use, and before putting the trimmer into storage for extended periods. Lightly oil the cutter and put on the cover. The cover supplied with the unit can be hung on the wall, providing a safe and practical way to store the hedge trimmer. [. . . ] Be careful not to accidentally contact a metal fence or other hard objects while trimming. Before removing or installing shear blade, always be sure that the tool is switched off and unplugged. â· When replacing the shear blade, always wear gloves without removing blade cover so that hands and face does not directly contact the blade. Do not wipe off grease from the gear and crank. [. . . ]