User manual MAKITA UK360D

[. . . ] Grip Battery hood Front carry handle Cultivator blade Transport wheel Rear carry handle Button Red indicator Battery cartridge Indicator lamps CHECK button Battery converter (BCV01) Installation hole Holder Battery port 1 Battery port 2 Rubber cap Product mounting adapter of the BCV01 19. Cord Slit in the lower housing Battery converter (BCV02) Indication lamps Battery lamp 1 Battery lamp 2 Warning lamp Battery selection switch Lock key Main switch Lock-off button Switch lever Drag bar Stopper Deep cultivation - A Middle depth cultivation - B Shallow cultivation - C Transport position - D Handle locking knob 38. Corn spring Tighten Lock pin and snap pin When blade is new When blade is worn Direction of blade rotation Blade facing inward Blade facing outward Left inner blades (outside view) Left outer blades (outside view) Right inner blades (outside view) Right outer blades (outside view) Outside Back view Lock pin Frame SPECIFICATIONS Model Dimensions Blade diameter Tilling width No load speed Net weight Rated voltage Standard battery cartridge and charger Always keep the combinations of battery/ charger on the right columns. 36 V BL3622A DC36WA • Due to our continuing programme of research and development, the specifications herein are subject to change without notice. [. . . ] €¢ When the upper two and lower two indicator lamps light alternately, the battery may have malfunctioned. contact your local Makita authorized service center. NOTE: • The indicated capacity may be lower than the actual level during use or immediately after using the tool. €¢ Depending on the conditions of use and the ambient temperature, the indication may differ slightly from the actual capacity. Indication lamp WARNING: • Do not use the battery selection switch during the operation. €¢ After flipping the battery selection switch, the main switch is turned off. To start the tool, the operator needs to press the main switch. 11 & 12) You can switch the battery by flipping the battery selection switch when the tool is equipped two batteries. ) If the tool is equipped one battery, flip the battery button to chose one side which the battery is equipped. €¢ If the tool is equipped one battery and you switch to a battery port in which no battery cartridge is mounted, the indication lamps shows the status No. The warning lamp lights up when a problem occurs, and the tool is automatically switched off about 10 seconds after the warning lamp has lighted. The indication of the warning lamp means as follows. €¢ Lighting-up-red: There are two possibility why the red lamp lights up. ) Turn off the main switch, and restart the tool after the motor cools down. ) Turn off the main switch, and recharge the battery cartridge. €¢ Blinking red: The blade becomes overloaded by getting stuck because of digging too deep, or clogged up by weeds or stone. The tool does not start up when the lock key is pulled out. 13 & 14) To switch on the tool, press the main switch. One of the indication lamp lights up when you switch on the tool. To switch off the tool, press the main switch again. To prevent the tool from unintentional starting, a lock-off button is provided. To start the blades’ rotating, depress the lock-off button and then pull the switch lever. [. . . ] Remove the battery, and insert it again carefully. Keep pressing the lock-off button when you pull switch lever. Turn off the tool by pressing the main switch. With either one battery of the two Battery is low. [. . . ]