User manual MAKITA UR360D

[. . . ] Speed change switch lever Indicator lamps Most effective cutting area CHECK button Spacer Nylon cutting head Bolts Protector cover Lock key Cutter holder 21. Cover Latches Press Spool For right hand rotation Notches Eyelets Protrusion (Not shown) Slot of the eyelet SPECIFICATIONS Model No load speed Overall length Cutting diameter with nylon cutting head Net weight Rated voltage Standard battery cartridge(s) Warning: Use only the battery cartridge(s) described. 36 V BL3622A/BL3626 • Due to our continuing program of research and development, the specifications herein are subject to change without notice. € Specifications and battery cartridge may differ from country to country. [. . . ] If the cartridge does not slide in easily, it is not being inserted correctly. Reversing is used only when weeds and debris are entangled in the tool. To operate the tool normally the “A” side of the switch should be depressed. If weeds and debris are jammed in the rotating head, the tool can be reversed by depressing the “B” side of the switch. WARNING: • Always be sure that the tool is switched off and battery cartridge is removed before removing weeds or debris entangled in the tool that is not removed by the reverse mode. Failure to switch off and remove the battery cartridge may result in serious personal injury from accidental start-up. NOTICE: • Always check the direction of rotation before operation. € Use the reversing switch only after the tool comes to a complete stop. Do not change the direction of rotation while the head is still rotating, the tool may be damaged. 8) Two speed ranges can be preselected with the speed change switch. Power switch action WARNING: • Before inserting the battery cartridge in the tool, always check to see that the switch trigger actuates properly and returns to the “OFF” position when released. Do not pull the switch trigger hard without pressing in the lock-off button. Operating a tool with a switch that does not actuate properly can lead to loss of control and serious personal injury. 6) To prevent the switch trigger from being accidentally pulled, a lock-off button is provided. To start the tool, press in the lock-off button and pull the switch trigger. The tool speed is increased by increasing pressure on the switch trigger. Bumping to this kind of objects may cause the tool damage. € Depending on the conditions of use and the ambient temperature, the indication may differ slightly from the actual capacity. ASSEMBLY WARNING: • Always be sure that the tool is switched off and battery cartridge is removed before carrying out any work on the tool. Failure to switch off and remove the battery cartridge may result in serious personal injury from accidental start-up. € Never start the tool unless it is completely assembled. Operation of the tool in a partially assembled state may result in serious personal injury from accidental start-up. [. . . ] Ask your local authorized service center for repair. abnormal vibration: Stop the tool immediately!Cutting head and motor cannot stop: Remove the battery immediately!012856 Bump the nylon cutting head against the One nylon cord has been broken and the ground while it is rotating to cause the head got unbalanced. [. . . ]