User manual MAKITA VC3210L

[. . . ] Press with a force and lower Protrusion of the pipe holder Groove Hook Holder plate Polyethylene bag Handle Head Cord hook Straight pipe Corner nozzle Stopper Model EU Voltage Power consumption Connected load for appliance socket Connected load for appliance socket Total connected load Volt Watt Watt at symbol mode Watt at symbol mode Watt VC1310L / VC2510L / VC3210L AU/NZ GB 110V 110 1, 050 650 950 2, 000 GB 230V 230 - 240 1, 050 2, 000 2, 400 3, 450 CL 220 1, 050 2, 400 2, 600 3, 650 AR 230 - 240 1, 050 1, 250 1, 600 2, 650 Model Volume flow (air) Vacuum Protection class Type of protection Recoverable capacity Dimensions (L x W x H) Net weight Dust Water Due to our continuing programme of research and development, the specifications herein are subject to change without notice. Specifications may differ from country to country. Weight according to EPTA-Procedure 01/2003 Symbols END108-2 The following show the symbols used for the equipment. Be sure that you understand their meaning before use. [. . . ] The cleaner has a float mechanism that prevents water from immersing into the motor when picking up more than a certain amount of water. When the tank is full and the cleaner no longer picks up water, switch off the cleaner and empty the tank. Before plugging the cleaner, always make sure that the cleaner is switched off. Plugging the cleaner with the switch on may cause an unexpected start resulting in serious personal injury. The suction power can be adjusted according to your work need. 2) Suction power can be increased by turning the suction force adjusting knob from the symbol to the symbol. When connecting an electric power tool, secure the power supply cord and hose using the holders at a 70 cm 80 cm distance among the holders that are provided with the cleaner so that the hose is not entangled by the power supply cord. Make sure that both the cleaner and the electric power tool are switched off before connecting or disconnecting. Connecting the power tool to the cleaner with both of them being switched on may cause unexpected and sudden start resulting serious personal injury. When connecting a grounded tool, insert a plug with a grounding plate to the socket of the cleaner. Never connect an electric power tool with an input power exceeding that specified in the "SPECIFICATIONS" to the socket of the cleaner by turning the suction force adjusting knob. Connecting the electric power tool exceeding the specified input power may cause overheat and damage to the cleaner. refer to the specifications to avoid this. The cleaner can be connected to an electric power tool up to input power shown in the "SPECIFICATIONS". To connect an electric power tool, open the cap and insert the power tool plug into the socket of the cleaner. 2) Move the suction force adjusting knob to the position suitable for the input power of the electric power tool you intend to use. Refer to the SPECIFICATIONS for the relation between suction force adjusting knob and the electric power tool input power. Switching on and off of the connected electric power tool simultaneously brings the cleaner switching on and off action. The cleaner still works for a few seconds even after the electric power tool is switched off. Be careful not to pinch your fingers when closing the base hook. Opening the base hook allows the following usage. Do not use the cleaner or a connected electric power tool with a power supply cord wound on the base hook. [. . . ] Empty the tank at least once a day although this depends on picked-up dust volume in the tank. Do not grab the hook when emptying the tank. 26) Shake off the dust from powder filter, damper and prefilter and then take the polyethylene bag out of the tank. (The hooks are away from the tank cover. [. . . ]