User manual MAKITA VR250D

[. . . ] Safety hints For your own safety, please refer to the enclosed safety instructions. Do not incinerate the battery cartridge even if it is severely damaged or is completely worn out. the battery cartridge can explode in a fire. Be careful not to drop or strike battery. [. . . ] Insert the vibrating head carefully between iron/ steel frames or reinforcing rods not to come in contact with them. Use a wet cloth or the like to carefully wipe off any wet concrete left on the tool after use. Extra care should be given to thorough cleaning of the vents, switch area, cover openings, etc. Before using battery cartridge, read all instructions and cautionary markings on (1) battery charger, (2) battery, and (3) product using battery. It may result in a risk of overheating, possible burns and even an explosion. If electrolyte gets into your eyes, rinse them out with clear water and seek medical attention right away. Always cover the battery terminals with the battery cover when the battery cartridge is not used. Do not short the battery cartridge: (1) Do not touch the terminals with any conductive material. A battery short can cause a large current flow, overheating, possible burns and even a breakdown. Do not store the tool and battery cartridge in locations where the temperature may reach or exceed 50°C (122°F). Always switch off the tool before insertion or removal of the battery cartridge. ⷠTo remove the battery cartridge, open the cover and withdraw the battery cartridge from the tool while pressing the buttons on both sides of the cartridge. ⷠTo insert the battery cartridge, align the tongue on the battery cartridge with the groove in the housing and slip it into place. Always insert it all the way until it locks in place with a little click. If not, it may accidentally fall out of the tool, causing injury to you or someone around you. ⷠDo not use force when inserting the battery cartridge. If the cartridge does not slide in easily, it is not being inserted correctly. CAUTION: Always be sure that the tool is switched off and the battery cartridge is removed before carrying out any work on the tool. To maintain product safety and reliability, repairs, maintenance or adjustment should be carried out by a Makita Authorized Service Center. These accessories or attachments are recommended for use with your Makita tool specified in this manual. [. . . ] This way the weight of the freshly poured concrete and vibration will lead to effective removal of air bubbles. 4) Conversely, if the pouring is done first from above, the mortar will separate and eventually slide to the bottom. : series production) manufactured by Makita Corporation in Japan is in compliance with the following standards or standardized documents, EN50260, EN55014 in accordance with Council Directives, 89/336/EEC and 98/37/EC. The typical A-weighted sound pressure level is 70 dB (A). [. . . ]