User manual MAMAS & PAPAS BIBI

[. . . ] 000000000000 000000000000 000000000000 Qty 1 1 1 -2- FITTINGS A x6 B Guides x2 Dowels C Guide screws x2 D x2 Metal studs E Long bolts x4 F Short bolts x2 G Base brackets x4 H Base bracket nuts x4 I Allen key x1 Fitting code: 000000000000 TOOLS Cross-head Screwdriver Hammer -3- A Insert four dowels (A) into the holes in the ends of the cots fixed side (1) top and bottom rails. Insert two dowels (A) into the holes in the ends of the support rail (2). You may need to gently tap the dowels into the holes using a light hammer. 1 2 STEP 1 C B Attach the two guides (B) to the front legs of the head (3) and foot (4) ends. [. . . ] Tighten the screws into the ends as shown in the diagram. Important: Do not over tighten the screws. The guides must turn freely. 3 STEP 2 4 --4-4 I D 3 Screw the metal studs (D) into the metal inserts in the front legs of the head end (3) and foot end (4) using the allen key (I). 4 STEP 3 1 Attach the fixed side (1) to the cot ends. Screw four long bolts (E) through the side rails of the fixed side and into the cot ends using the allen key (I). Important: Do not fully tighten the long bolts. STEP 4 E I --5-5 Slot the dowels into the ends of the support rail (2) into the holes in the cot ends. Insert two short bolts (F) into the holes in the cot ends and screw into the support rail using the allen key (F). STEP 5 2 F I 5 With the help of another person carefully turn the cot over so that the fixedside faces down. Ensure that the two short bolts used to attach the support rail are half tight. Lower the drop side (5) into position between the cot ends. Ensure that the plastic teething rail is at the top and that the drop side mechanism is positioned the correct way round. Plastic teething rail STEP 6 --6-6 5 Align the guides (B) on the cot ends with the metal runners in the drop side (5). · There should be a minimum of 200mm between the top of the mattress and the upper edge of the cot side when the base is set in the highest position. This distance is indicated by the mattress height mark engraved in the cot. · The mattress should be no more than 40mm shorter or narrower than the internal length or width of the cot. · If you leave the child unattended in the cot, always make sure that the drop side is in the highest position. · Never leave anything in the cot which could provide a foothold for your child to climb out or would present a danger of suffocation or strangulation. · Ensure that there are no loose screws that could trap parts of the child's body or clothing (e. g. ribbons, drawstrings, necklaces) or pose a risk of strangulation. · Regularly check that all fittings and components of the cot are fully tightened and in working order. If any parts have become worn or damaged then do not use the cot. [. . . ] Seek advice by calling Customer Care on: +44 (0)845 268 2000. · Do not use replacement parts that are not recommended or supplied by Mamas & Papas. · Non-approved parts may render the repair or cot unsafe. [. . . ]