User manual MAPLE CHASE SERVERSTAT THERMOSTAT 0960

[. . . ] Pass them on to any new owners of the appliance. A board must be installed under the hob if it is not installed above an oven. Please, refer to the “Installation Instructions” for minimum dimensions. 5 mm min. It may present a choking or suffocation hazard (see Precautions and tips). [. . . ] • TIMER* indicator light shows that the timer has been activated !This product complies with the requirements of the latest European Directive on the limitation of power consumption of the standby mode. If no operations are carried out for a period of 2 minutes, after the residual heat indicator lights turn off and the fan stops (if present), the appliance automatically switches to the “off mode”. The appliance resumes the operating mode once the ON/OFF button is pressed. * Only available in certain models. 5 Start-up and use !The glue applied on the gaskets leaves traces of GB Switching off the cooking zones To switch off a cooking zone, select it using the corresponding selector button • Press the and: grease on the glass. Before using the appliance, we recommend you remove these with a special nonabrasive cleaning product. During the first few hours of use there may be a smell of rubber which will disappear very quickly. !A few seconds after the hob is connected to the - button: the power of the cooking zone will progressively decrease until it is switched off. electricity supply, a buzzer will sound. If the Heating elements Two types of heating element may be installed, depending on the appliance model: halogen and radiant elements. Halogen elements emit heat via radiation from the halogen lamps they contain. They have similar properties to gas burners: they are easy to control and reach set temperatures quickly, allowing you to see the power level instantly. When the safety switch has been triggered, the display shows “0”. 0 For example: the right rear hotplate is set to 5 and will switch off after 5 hours of continuous operation, while the front left hotplate is set to 2 and will switch off after 8 hours. Safety devices Pan sensor Power level Maximum operating time in hours 9 8 7 6 5 4 3 2 1 Each cooking zone is equipped with a pan sensor device. The hotplate only emits heat when a pan with suitable measurements for the cooking zone is placed on it. If the indicator light is flashing, it may indicate: • An incompatible pan • A pan whose diameter is too small • The pan has been removed from the hotplate. Residual heat indicators Each cooking zone is equipped with a residual heat indicator. This indicator signals which cooking zones are still at a high temperature. If the power display shows , the cooking zone is still hot. It is possible, for example, to keep a dish warm or melt butter or chocolate. As the cooking zone cools, the power display will show . The display switches off when the cooking zone has cooled sufficiently. Overheating protection If the electronic elements overheat, the hob switches off automatically and 1 2 3 4 5 6 7 8 9 Buzzer This can also indicate several irregularities: • An object (a pan, cutlery, etc. ) has been placed on the control panel for more than 10 seconds. [. . . ] • Do not look at the halogen lamps in the cooking zones for long if they are present. • Do not let children play with the appliance. • The appliance is not intended to be operated by means of an external timer or separate remote-control system. • Children should be supervised to ensure that they do not play with the appliance. 10 Care and maintenance • To remove more stubborn dirt, use a suitable scraper. [. . . ]