User manual MARANTZ 74 CD-57 SERVICE MANUAL

[. . . ] Install in accordance with the manufacture's instructions. Do not install near any heat sources such as radiators, heat registers, stoves, or other apparatus (including amplifiers) that produce heat. Do not defeat the safety purpose of the polarized or grounding-type plug. A polarized plug has two blades with one wider than the other. [. . . ] (See page 14) c 0 OPEN/CLOSE button /6 TIME button This button is used to switch the time display. Each time it is pressed, the displayed time cycles from "track elapsed time" "track remaining time" "total remaining time" "track elapsed time". (See page 18) /5 /4 /3 /2 Press this button to open the tray. Press the button again to close the tray. , DISC1-DISC5 (Disc Select button) Choose a disc to play. v Caution Do not press the disc tray in by hand. REPEAT button Playback a track or disc repeatedly. Use this button also to switch to the Repeat mode (One Track Repeat, One Disc Repeat, and All Disc Repeat). (See page 15) /7 DIMMER button This button is used to adjust the brightness of the display window. v PROGRAM button This button is for program play. (See page 15) b /1 n m , RANDOM AMS REPEAT b 4, ¢ (Track Skip buttons) 4: When this button is pressed, the unit goes back to the beginning of the current track. If the button is pressed more times, the track being played is skipped back. ¢: Each time this button is pressed, the track being played is skipped forward. · Search buttons are provided separately for the remote control unit. · Do not insert a disc in the way shown as the arrow. NORMAL PLAYBACK OPEN/CLOSE PLAY STOP PAUSE 5 DISC CD CHANGER 74 CD-57 1 2 3 4 5 DISC SKIP REPEAT RANDOM LEVEL STANDBY ON STANDBY POWER ON/STANDBY PHONES OPEN/CLOSE TIME DIMMER 1 4 7 A C IN 2 5 8 0 3 6 1. 3. OPEN/CLOSE PLAY STOP PAUSE 5 DISC CD CHANGER 74 CD-57 9 RECALL 1 2 3 4 5 DISC SKIP REPEAT RANDOM PROGRAM LEVEL 4. · Do not touch the back side (shiny side) of a CD. · To play a single CD (8 cm), place the disc with the indentation at the center of the tray. STANDBY POWER ON/STANDBY PHONES 2. 2. Turn on the power switch of the audio unit (amplifier, etc. ) that is connected with this unit. Set the selector on the connected unit to this unit. Plug the power cable into an AC outlet. RANDOM AMS REPEAT DISC 1 DISC 2 DISC 3 DISC 4 DISC 5 To set multiple discs, press DISC SKIP button on the main unit. With the turn table on the tray rotating, set the disc one by one. Press 0 OPEN/CLOSE button on the main unit or remote control unit to close the disc tray. 3. REMOTE CONTROLLER RC4001CC 3. 4. Turn the power on by pressing POWER ON/STANDBY button on the unit or ON button on the remote control unit. · The unit repeats switching from ON and Standby every time the POWER ON/STANDBY button is pressed. 2. 5 DISC CD CHANGER 74 CD-57 1 MP3 CD PROGRAM R TRACK DISC TOTAL EACH REMAIN MIN SEC 12345 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 1. 3. OPEN/CLOSE PLAY 2 3 4 5 RANDOM REPEAT 1DISC 4. STOP PAUSE RANDOM 4. 1 2 3 4 5 DISC SKIP REPEAT LEVEL STANDBY POWER ON/STANDBY PHONES When 3 PLAY button on the main unit or remote control unit is pressed, playback starts from the first track. · At this time, "3" lights up on the display window. [. . . ] The problem is likely to have been caused by a simple operational error. If the problem cannot be corrected even after carrying out the following checks, consult your dealer or nearest Marantz sales office or service counter. # The disc stops in mid-operation. The sound drops out or noise is heard. 1. * In the case of a CD-R or CD-RW disc, this problem may occur when the conditions under which its data was originally written were substandard or when the quality of the disc itself is poor. [. . . ]