User manual MARANTZ CDR310

[. . . ] Model CDR310 User Guide CD Recorder CLASS 1 LASER PRODUCT LUOKAN 1 LASERLAITE KLASS 1 LASERAPPARAT CAUTION RISK OF ELECTRIC SHOCK DO NOT OPEN CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE COVER (OR BACK). REFER SERVICING TO QUALIFIED SERVICE PERSONNEL. The lightning flash with arrowhead symbol within an equilateral triangle is intended to alert the user to the presence of uninsulated "dangerous voltage" within the product's enclosure that may be of sufficient magnitude to constitute a risk of electric shock to persons. The exclamation point within an equilateral triangle is intended to alert the user to the presence of important operating and maintenance (servicing) instructions in the literature accompanying the product. WARNING TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK, DO NOT EXPOSE THIS APPLIANCE TO RAIN OR MOISTURE. CAUTION: USE OF CONTROLS OR ADJUSTMENTS OR PERFORMANCE OF PROCEDURE OTHER THAN THOSE SPECIFIED HEREIN MAY RESULT IN HAZARDOUS RADIATION EXPOSURE. LASER SAFETY This unit employs a laser. Only a qualified service person should remove the cover or attempt to service this device, due to possible eye injury. Copyright Recording and playback of any material may require consent. For further information refer to the following US ordinances: · Copyright act of 1956 · Dramatic and Musical Performance Act 1958 · Performers Protection Acts 1963 and 1972 · any subsequent statutory enactments and orders i IMPORTANT SAFETY INSTRUCTIONS READ BEFORE OPERATING EQUIPMENT This product was designed and manufactured to meet strict quality and safety standards. [. . . ] When burning data from the HD to a CD-R, the CD burning process will not start if there is not enough battery power remaining. Furthermore, if the batteries run out while burning to the CD-R, recording will stop and the recorder will shut down. If this happens, the CD burning process may not complete correctly. Charging the optional Ni-Cd battery · Load the Ni-Cd battery correctly in the battery compartment. · Connect the AC power pack and AC adaptor into power supply. · Select Ni-Cd in the battery type menu. ( P. 13) · Power the CDR310 on, then off for the charging cycle to begin. · The CDR310 must be off during battery charging. While charging (about 3 hours), the CHARGE indicator will be lit and steady. When the Ni-Cd battery charge cycle is complete, the CHARGE indicator will be off. Safety cautions on handling batteries Always follow the points below when using batteries to avoid electrolyte leakage, overheating, fire, rupturing, ingestion, etc. Electrolyte leakage or corrosion may occur if batteries are kept inside the recorder for prolonged periods of time. If the recorder is not to be used for a prolonged period, remove the batteries to prevent electrolyte leakage. Make sure that the + and ­ markings on the batteries are aligned with the corresponding markings in the battery case and the battery holder. Do not recharge, heat, or disassemble batteries. Do not throw dry cell batteries onto a fire. Do not insert old or exhausted batteries into the recorder. Do not mix the type of battery, and do not use both old and new batteries together. If the recorder does not operate correctly, replace the old batteries with new ones. If electrolyte has leaked, thoroughly wipe the inside of the battery holder, and then insert new batteries. 12 Basic Operations Power on/off Set the battery type for the recorder to match the type of batteries you are using. < Default value > Alkaline 1 Slide the power switch to switch the power ON. Notes The factory-preset settings are set to record sound using the external microphone input. Refer to "Menu Settings" for details on the default settings of the various menus. ( P. 17) 1 While the recorder is stopped, press the MENU/STORE button. 2 Turn the JOG to select "Batt Type" and press the JOG. · At this time, the display shows "Loading". The recorder's BOOT process starts. 3 · The recorder stops when the BOOT process completes. Turn the JOG to select the type of battery, and press the JOG. 2 Slide the power switch to switch the power OFF. Display Alkaline NiCd NiMH Battery type Alkaline battery Optional Nickel-Cadmium battery Optional Nickel-Metal Hydride battery 4 Press the MENU/STORE button to register the settings. 13 ENGLISH Battery type settings Battery remaining indicator The recorder operates using commercially available AA size alkaline batteries, the optional Nickel-Cadmium battery, or the optional Nickel-Metal Hydride battery. [. . . ] Cleaning, check-ups with no fault found or changes incurred for installation, removal or reinstallation of the product. Any serialized product on which the serial number has been defaced, modified or removed. Accessories, including but not limited to: cables, mounting hardware and brackets, cleaning accessories, power cords and adapters, and carry cases. Non-transferable warranty This Warranty may be enforced only by the original purchaser. [. . . ]