User manual MARANTZ MM8077

[. . . ] The lightning flash with arrowhead symbol, within an equilateral triangle, is intended to alert the user to the presence of uninsulated “dangerous voltage” within the product’s enclosure that may be of sufficient magnitude to constitute a risk of electric shock to persons. The exclamation point within an equilateral triangle is intended to alert the user to the presence of important operating and maintenance (servicing) instructions in the literature accompanying the appliance. install in accordance with the manufacturer’s instructions. Do not install near any heat sources such as radiators, heat registers, stoves, or other apparatus (including amplifiers) that produce heat. [. . . ] These improvements to the power supply capability provide a powerful, presence-filled sound. This unit is equipped with a remote power control function. When a marantz AV Pre Tuner AV8801 or AV7701 is connected to this unit, this unit’s power can be switched ON/OFF together with the AV8801 or AV7701 power supply. Connection to the AV8801 or AV7701 is a ground floating connection that prevents negative influences on sound quality as far as possible. Other Functions Equipped with IR flash input that supports custom installations, and DC trigger input and output terminals. High sound quality design based on pure surround philosophy Equipped with a chimney-shaped heat sink to efficiently process the heat emitted from each channel amp , and exceptionally quiet cooling fans. A high-sensitivity temperature sensor IC is used to control the cooling fans, adjusting the rotation speed to match the amount of heat generated by the amp. These components provide the sound quality and low-noise you would expect at a high-end theater. In addition, this unit is designed for superb quality sound, and is equipped with high quality components such as a high-end audio condenser and film condenser throughout. Indd 2 2012/10/15 13:15:20 ENGLISH Part names Front panel For buttons not explained here, see the page indicated in parentheses ( ). Getting started Rear panel See the page indicated in parentheses ( ). (9) • Press this button to turn the illumination lamp ON/OFF. € You can set the auto standby function by pressing and holding this button for more than 5 seconds. Indd 3 2012/10/15 13:15:21 ENGLISH Connections NOTE • Do not plug in the power cord until all connections have been completed. € When making connections, also refer to the operating instructions of the other components being connected. € Check the channel, and then connect correctly. € Do not bundle power cords together with connection cables. NnXLR connector PIN arrangement The PIN arrangement in this device uses the European method. in the USA method , w is COLD , and e is HOT. When connecting a device that utilizes the USA type of PIN arrangement, replace the w and e plugs on one side of the balanced cable. NOTE Do not short the HOT and GND or COLD and GND for use. Preparations Cables used for connections Prepare the correct cables for use with the additional devices. [. . . ] Should the problem persist, there may be a malfunction. In this case, disconnect the power immediately and contact your store of purchase. Symptom Cause/Solution Page 7 7, 10 The power does not switch on. € Check that the power plug is inserted correctly in the wall socket. [. . . ]