User manual MARANTZ PM4400

[. . . ] Model PM4400 User Guide INTEGRATED AMPLIFIER ENGLISH WARRANTY For warranty information, contact your local Marantz distributor. RETAIN YOUR PURCHASE RECEIPT Your purchase receipt is your permanent record of a valuable purchase. It should be kept in a safe place to be referred to as necessary for insurance purposes or when corresponding with Marantz. ITALIANO GARANZIA L'apparecchio è coperto da una garanzia di buon funzionamento della durata di un anno, o del periodo previsto dalla legge, a partire dalla data di acquisto comprovata da un documento attestante il nominativo del Rivenditore e la data di vendita. La garanzia sarà prestata con la sostituzione o la riparazione gratuita delle parti difettose. [. . . ] BALANCE CONTROL Turn the knob to correct an unbalanced program source such as stereo broadcast or to vary the output level of the left or right channel. Note that, if the BALANCE control is turned fully in one direction, the sound will not be heard from the speaker on the other side. SPEAKERS 1 / 2 SWITCHES These switches are used to select the speaker system(s) connected to the SPEAKER SYSTEM 1 / 2 terminals on the rear panel. If both the 1 and 2 switches are pressed to the low positions, two speaker systems can be used at the same time. When headphones are used for listening, set both switches 1 and 2 to OFF (high positions). BASS AND TREBLE TONE CONTROLS Adjusts the tone by controlling the levels of two frequency bands. Turn each control toward (+) to enhance the corresponding frequency band, or toward (­) to attenuate it. TREBLE: Adjusts the high frequency level. REC SELECTOR SWITCH Selects the tape dubbing mode between tape decks or the signal output at the REC OUT jacks. REMOTE SENSOR The remote sensor receives the infrared commands from the remote control unit. When an infrared signal is received from the remote control unit. The remote control unit must always be pointed directry at the remote sensor. PHONES JACK Insert the standard phone plug of the headphones into this jack. !7 !8 !9 i o @0 !0 POWER CORD Connect to a household power outlet. POWER SWITCH Pressing once switches the power ON, and pressing again switches it OFF. The POWER indicator lights when the POWER switch is ON, and go out when the POWER switch is OFF. !1 @1 @2 !2 INPUT SELECTOR Selects the program source to be recorded or played from the PHONO, CD, TUNER, AUX/DVD, CD-R, and MD/TAPE. STANDBY INDICATOR Lights up when the unit is in the stand-by mode. !3 @3 !4 TONE DEFEAT SWITCH ¡ When the switch is not depressed, the audio signals are applied to the tone control circuit and the tone can be adjusted using the tone control knob. ¡ When the switch is depressed, the audio signals bypass the tone control circuit and the tone control knob does not function. 5 English q PHONO INPUT JACKS Connect the output jacks of a turntable to these jacks. !5 English OPERATION PROCEDURES RECORDER OPERATION INTEGRATED AMPLIFIER PM4400 INTEGRATED AMPLIFIER PM4400 INPUT SELECTOR VOLUME PHONO CD TUNER AUX/DVD CD-R MD/TAPE INPUT SELECTOR PHONO CD TUNER AUX/DVD CD-R MD/TAPE VOLUME TONE DEFEAT MUTE LOUDNESS TONE DEFEAT MUTE LOUDNESS ON OFF ON OFF ON OFF ON OFF REC SELECTOR OFF BASS TREBLE 1 SPEAKERS 2 MIN MAX BALANCE REC SELECTOR OFF BASS TREBLE 1 SPEAKERS 2 MIN MAX BALANCE POWER ON/OFF PHONES STANDBY SOURCE PHONO CD TUNER POWER ON/OFF PHONES STANDBY SOURCE PHONO CD TUNER COPY AUX/DVD ­ + ­ + ON OFF COPY L R AUX/DVD ­ + ­ + ON OFF L R REC SELECTOR Operate each equipment to start play. Control used for operating the tape deck. TO PLAY AN ANALOG DISC 1. Set the INPUT SELECTOR switch q to PHONO. Adjust the volume with the VOLUME control w and adjust the tone with the BASS and TREBLE controls e. NOTES: ¡ Set the VOLUME control to the minimum position before placing the stylus on the disc or before replacing the cartridge. ¡ Do not apply shock or vibration to the turntable during play, as this may cause the stylus to jump and the analog disk to be damaged. ¡ If the turntable is installed too close to the speakers, the volume may not be able to be increased to a high level due to howling. ¡ Do not switch the power OFF while the stylus is on the disc surface. Set the INPUT SELECTOR switch q to TUNER. [. . . ] 30 / 40 W DIN 8 Ohms / 4 Ohms . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 35 / 45 W IHF dynamic power 8 Ohms / 4 Ohms . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 50 / 80 W THD at 8 Ohms RMS rated output . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 0. 005% Intermodulation distortion . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ]