User manual MARANTZ RC3001

[. . . ] 31 1:03:54 PM For US and Canada Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. [. . . ] €¢ To change the channel of the remote controller, change the channel setting in the Wizz. 31 1:04:40 PM The RC3001 can use the Wizz. It 3 editor to set the group ID for each device. If a different ID signal is sent from the remote controller, no control signal is output from the RX3001. Normally, set to ID1 when not using the group ID function. Group ID Receiver side Emitter Output 1 2 3 4 5 6 Receiver side Emitter Output 1 2 3 4 5 6 1 Set ID 1 Set ID 1 Set ID 1 Set ID 1 Set ID 1 Set ID 1 ID 1 2 Group ID 2 Set ID 1 Set ID 1 Set ID 1 Set ID 2 Set ID 2 Set ID 2 Output from the Output jack is controlled as shown below based on the remote device ID setting and receiver ID setting. It 3 editor software can be used to make the settings for the IR Command, LINK, JUMP, One Touch Operation (Macro) and other functions in the RC3001. This enables a customized user interface, optimized for the customer s environment, to be built. It 3 editor software can be downloaded from www. For more information about the setting procedures, see the PC Editor Software Wizz. This is the basic operation procedure for the RC3001. SLEEP TIMER The SLEEP TIMER is a function that sends a preset remote command after the sleep time has elapsed. €¢ The setting is made using the Wizz. It 3 editor, and the buttons that are assigned to the sleep timer are operated as shown below. €¢ This is a convenient function for devices that do not have a sleep timer or for setting the sleep timer using multiple devices. Press the button that will be assigned to the sleep timer. Each time the button is pressed, the sleep setting time changes in the cycle shown below. Press the Home button to enter Home mode for the RC3001. Select the devices that are set in Home mode. Perform operation of the device that you want to control in the selected device mode. To control another device, return to Home mode and select another device. The preinstalled default user file is used to control Marantz products. [. . . ] Display the MAIN MENU on the LCD of the RC3001, then press the button next to the STATUS indicator. Pressing the ENTER button cycles through the statuses of each of the items below. €¢ Remaining learning memory • Remaining macro steps • LCD timer setting • Backlight timer setting • Beep setting • Firmware version • Current clock time Either press the ENTER button or wait three seconds so that the LCD returns to the MAIN MENU. Use a paper clip or other object to press the reset button in the reset hole as shown in the figure below to reset the RC3001. [. . . ]