User manual MARANTZ RC5001SR

[. . . ] Model SR4001/SR5001 User Guide AV Surround Receiver CAUTION RISK OF ELECTRIC SHOCK DO NOT OPEN CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE COVER (OR BACK) NO USER-SERVICEABLE PARTS INSIDE REFER SERVICING TO QUALIFIED SERVICE PERSONNEL The lightning flash with arrowhead symbol within an equilateral triangle is intended to alert the user to the presence of uninsulated “dangerous voltage” within the product’s enclosure that may be of sufficient magnitude to constitute a risk of electric shock to persons. The exclamation point within an equilateral triangle is intended to alert the user to the presence of important operating and maintenance (servicing) instructions in the literature accompanying the product. iMPORTANT SAFETY INSTRUCTIONS READ BEFORE OPERATING EQUIPMENT 9. This product was designed and manufactured to meet strict quality and safety standards. [. . . ] Select one of the crossover frequency levels according to the size of the small speaker connected. 80Hz → 100Hz → 120Hz → 150Hz → 180Hz Notes: • If using small front speakers, set a slightly higher frequency. If using large front speakers, set a slightly lower frequency. 1CH Input is in use, this function does not take effect. BASS MIX • The bass mix setting is only valid when “LARGE” is set for the front speakers and “YES” is set for the subwoofer during stereo playback . This setting has effect only during playback of PCM or analog stereo sources. € When “BOTH” is selected, the low frequencies will be played through the main L&R, as well as the sub woofer. In this playback mode, the low frequency range expand more uniformly through the room, but depending on the size and shape of the room, interference may result in a decrease of the actual volume of the low frequency range. € By selecting “MIX”, the low frequencies will play through the main L&R only. Note: LFE signals during playback of Dolby Digital or DTS, will be played through the sub woofer. ENGLISH 2 SPEAKER SETUP After you have installed the SR4001/SR5001, connected all the components, and determined the speaker layout, it is now time to perform the settings in the Speaker Setup menu for the optimum sound acoustics for your environment and speaker layout. Before you perform the following settings, it is important that you first determine the following characteristics: 1-2 INPUT SETUP FUNC:MODE :DIG:HDMI:COMP -----------------------CD :AUTO : 4 : : TAPE:AUTO : - : : CD-R:AUTO : 5 : : AUX2:AUTO : - : : 2-1 SPEAKERS SIZE When setting the speaker size in the SPEAKER SIZE sub-menu, use the guidelines given below. LARGE: The complete frequency range for the channel you are setting will be output from the speaker. SMALL: Frequencies of the channel you are setting lower than approx. 100 Hz will be output from the subwoofer. If the Subwoofer is set to “NONE” and the front speakers are set to “LARGE, ” then the sound will be output from both the left and right speakers. To select the input source and MODE, press the 3 or 4 cursor buttons. To select “DIG” “HDMI” or “COMP” for the input jack, press the 1 or 2 cursor buttons. Select “DIG” for input sources, for automatic detection of the digital input signal condition. If there is not a digital signal present, but there is an analog signal present, the analog signal will be played. select “DIG” , when only a digital signal will be used. Select “ANA” for input sources for which no digital input jacks are used. [. . . ] Sound will be output from the center speaker. Center = NONE has been selected in Make the correct setting. The surround speaker cable connection Connect the cable correctly. STEREO has been selected for Surround When STEREO has been selected for Surround mode. [. . . ]