User manual MARANTZ RC7200SR

[. . . ] RETAIN YOUR PURCHASE RECEIPT Your purchase receipt is your permanent record of a valuable purchase. It should be kept in a safe place to be referred to as necessary for insurance purposes or when corresponding with Marantz. IMPORTANT When seeking warranty service, it is the responsibility of the consumer to establish proof and date of purchase. Your purchase receipt or invoice is adequate for such proof. [. . . ] Q VIDEO SOURCE: Displays the current video source being selected with the function selector TV, DVD, VCR1, DSS or AUX. W AUDIO SOURCE: Displays the current audio source being selected with the function selector FM, AM (MW, LW), CD, TAPE, CD-R, TV, DVD, VCR1, DSS or AUX. E DIGITAL INPUT: Displays the digital input that you are using DIG-1, DIG-2, DIG-3, DIG-4 or DIG-5. Press the POWER ON button, or select the desired source on multi room remote control unit from the MULTI ROOM. Any of these operations will put the SR7200 into multi room mode and “MULTI ROOM” indicator will light and OSD system for the TV in the multi room will be shown. DOWN button on the multi room remote control unit to set the desired sound volume. In multi room mode, the multi room remote control unit can be used in the multi room to operate the following functions. You can select a tuner preset channel and tuning up or down, and direct selection. And you can control the CD player, DVD player VCR and tape deck connected to the SR7200. Additionally, SLEEP timer function for multi room is available from second zone, by pressing the SLEEP button on the multi room remote control unit. The status of the main room setting can be monitored from the second zone with the OSD. 1 CH SURR, PLO LOGIC, PLII MUSIC, PLII MOVIE, DTS t MULTI ROOM Displays the current status of the Multi Room function, ON or OFF. y MASTER VOLUME Displays the current volume level. The volume level is higher at the right of the display. Note: The On-Screen Display signals for the main room can be output from the TV MONI composite video (RCA) output and the TV MONI, S-Video and TV MONI component video output jacks. With some video equipment or software, the On-Screen Display characters may be distorted due to noise or tracking adjustment error. Caution: If the main room and the secondary room are listening to the tuner, the main room will have priority over controlling that source. For example, you cannot change the frequency or preset of the Tuner from a remote location if the main room is also listening to that source. When TV, DSS, DVD, VCR1 or AUX is selected with the function selector, both AUDIO and VIDEO shows the same name. Then there is no indication on the TV display. Press the OSD button ⁄7 again to activate the OSD. MASTER VOLUME CONTROL Displayed when the MASTER volume is varied or a button of the remote control unit is pressed. [. . . ] If that happens, input the preset data again. Replace all the batteries with new ones. The headphones are connected to the jack. Noise is produced during DTS- Analog has been selected for input. [. . . ]