User manual MARANTZ SA-7S1

[. . . ] Model SA-7S1 User Guide Super Audio CD Player CLASS 1 LASER PRODUCT LUOKAN 1 LASERLAITE KLASS 1 LASERAPPARAT ENGLISH WARRANTY For warranty information, contact your local Marantz distributor. RETAIN YOUR PURCHASE RECEIPT Your purchase receipt is your permanent record of a valuable purchase. It should be kept in a safe place to be referred to as necessary for insurance purposes or when corresponding with Marantz. IMPORTANT When seeking warranty service, it is the responsibility of the consumer to establish proof and date of purchase. [. . . ] (See page 14) ¤9 DC FILTER button This button is pressed to turn the DC filter on and off. (See page 14) <0 FILTER button This button is pressed to make the digital filter settings. Each time it is pressed, the settings cycle from FIL1 FIL2 FIL3 FIL1. (See page 15) <1 DIGITAL OUT button This button is pressed to turn the digital output for the Audio CD signal on and off. (See page 14) <2 INPUT button This button is pressed to switch the input when using one of the supported Marantz amplifiers (supported models as of September 2006: SC-7S2, PM-11S1, PM-15S1, PM7001, PM7001KI, SR9600). <3 VOLUME button This button can be used to adjust the volume when a Marantz amplifier that has a remote control is used. 8 REAR PANEL A B C D E F A ANALOG OUTPUTS UNBALANCED connectors These are the unbalanced output jacks of the analog audio signals. The analog connection cord can be connected to the CD, AUX, or other connectors on an amplifier. Be sure to connect the L and R channels correctly to the corresponding jacks. * Never connect to the PHONO connector on the amplifier. E DIGITAL OUTPUTS OPT. (Optical digital output connector) The audio CD signal being played is output digitally. Connect a recording device, amp, D/A converter etc. that has an optical digital input connector using a commercially available square-shaped optical cable. * No signal is output when Digital Out OFF is set. * No signal is output when playing a super audio CD. B ANALOG OUTPUTS BALANCED connectors These are the balanced output jacks of the analog audio signals. A balanced connection cord (available commercially) can be connected to the balanced input jack of the amplifier. Be sure to connect the L and R channels correctly to the corresponding jack. (See page 22) * If connecting the balanced output jacks, be sure to leave the unbalanced jacks unconnected. (The balanced and unbalanced connectors cannot be used at the same time. ) F AC POWER INPUT JACK Connect the supplied power cord to this jack and a household AC power outlet. C EXT. CLOCK INPUT (External clock) Connector This is the input connector for the clock frequency from an external master clock generator. Connect the master clock generator to the BNC terminal coaxial cable (75 ). D DIGITAL OUTPUTS COAX. (Coaxial digital output connector) The audio CD signal being played is output digitally. Connect a recording device, amp, D/A converter etc. that has a coaxial digital input connector using a commercially available coaxial cable. [. . . ] * This condition may occur in Mixed-Mode CDs, CD Extra, and other discs that have CDDA format mixed with other data. Noise may also be heard momentarily when skipping tracks. · Remote control operation is not possible. Is the transmitter of the remote control unit pointed correctly at the remote sensor on the front of the player (this unit)? [. . . ]