User manual MARANTZ TT 42

[. . . ] This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: Reorient or relocate the receiving antenna. Increase the separation between the equipment and receiver. [. . . ] Press the access code button again to hear the next access code. When you hear the access code you wish to change press the DONE Button. Enter 3-6 new numbers using the numbered keys. (Access Code length is programmed by the installer. ) Close the panel cover. How to Delete an Access Code: Delete Access Code Delete 1. 5. 6. Open the cover of the panel. The panel voice prompts you to Use numbered keys to enter ID. Enter your master access code using the numbered keys. The panel voice prompts you to Please select from START MENU. Press the Delete button on the START MENU. The panel voice prompts you to Select from MAIN MENU. Press the Access Code button on the MAIN MENU. Press the Hours and Minutes buttons to set the correct off time. Panel will announce the unit number with the on and off times you just programmed. Programming Options The following table is a list of options you can change. Programming Options Option # 01 - Panel Beeps 02 - Panel Voice 03 - Latchkey Time 36 - Sensor Activated Light Lockout Start Time 37 - Sensor Activated Light Lockout Stop Time 41 - Chime Voice 42 - Speaker Volume 43 - Pager Phone Number 55 - Status Beep Volume 81 - Heating Set Point 82 - Cooling Set Point On On 12:00 am (midnight) to 11:59 pm 12:00 am (midnight) to 11:59 pm 12:00 am (midnight) to 11:59 pm On 1-8 Up to 26 digits* 1 - 10 51F - 91F 51F - 91F Add Delete Off Off Off Off Off Off 8 (highest) Off 7 Off Off * See "Option 43 - Pager Phone Number" Press Add in the START MENU and follow the voice prompts to turn an option on. Press Delete in the START MENU to turn an option off. When entering a single digit option number (1-9), you must type a zero before the number (i. e. All option numbers must be 2 digits. 16 Simon Security System Option 01 - Status Beeps Add this option to enable panel beeps. Status beeps are any beeps (including chime beeps) that come from the panel. Panel announces, Use numbered keys to enter ID. Enter Access Code using the numbered keys. Panel announces, Please select from Start Menu. Panel announces, Option 1, press again for next option or done to select 5. Panel announces, Use numbered keys to enter ID. [. . . ] If intruders have the technical means of bypassing, jamming, or disconnecting all or part of the system. If power to sensors is inadequate or disconnected. If freeze or any environmental sensors are not located in areas where the appropriate condition can be detected. For example, Smoke Sensors cannot detect smoke in chimneys, walls, roofs, or smoke blocked by a closed door. [. . . ]