User manual MARMITEK EASYTOUCH 35 BROCHURE

[. . . ] Safety Warnings __________________________________________________________4 Introduction _____________________________________________________________5 Installing the batteries ____________________________________________________6 Description of the ET35 "rubber" keys _______________________________________6 Description of the ET35 "Touchscreen" keys __________________________________7 Programming the EasyTouch35 ____________________________________________9 Method A: Programming using the Brand Search method _______________________9 Method B: Programming using the 3 Digit Code Tables ________________________10 Method C: Programming using the Manual Code Search-method _______________11 Identifying codes found using the search procedures __________________________12 Programming a Macro____________________________________________________12 Channel toggle key ______________________________________________________14 Setting key labels ________________________________________________________15 Code learning___________________________________________________________16 Marmitek X-10 Home Automation _________________________________________17 12. To prevent short circuits, this product should only be used inside and only in dry spaces. Do not expose the components to rain or moisture. Do not use the product close to a bath, swimming pool etc. [. . . ] Press and hold Setup key until the LED remains on (this occurs after approximately 2-3 seconds) and the display shows the Main Setup Screen. Press and release the digit key the Macro is to be stored under. the Macro Mode Setup Screen will be shown. The first key stored in a Macro must be a Mode key. Press and release desired Mode key (TV, VCR, SAT, etc. Press and release the remote keys (maximum of 20) that are required to be stored in the exact order that they should be transmitted. Use the Touchscreen "SCREEN" key to toggle the screen keys displayed and use the Mode keys for any Mode changes. The Setup key can be used to add delays ­ see separate notes. Note - if you program the maximum of 20 keys, then the Macro will be automatically stored on the 20th keypress. Press and release the Touchscreen "EXIT" key to return to normal operation. "SHIFTED" key commands cannot be included in Macros. 5 second between each IR transmission in the sequence. It may be necessary to have "delays" included in the Macro sequence (e. To enter a delay of 4 seconds, press and release Setup followed by 4. First Setup keypress takes you to the "Delay" screen and the second Setup press results in abort and exit. It is not possible to include a Macro within a Macro. Press and hold the Setup key until the LED remains on (this occurs after approximately 2-3 seconds) and the display shows Main Setup Screen. Press and release the digit key for the Macro that is to be deleted. the LED will blink off and the Macro is deleted. The Channel-Toggle "P<P" key is a special type of Macro key. The feature allows you to program in two specific fixed channels and switch between them with a single key-press. For example, you may want to switch between TV channels 123 and 456. [. . . ] DVD), Cable or SAT library device without the need to change to TV Mode. This feature is also available if the Marmitek X-10 Home Automation key is programmed to control a second VCR, Cable or SAT device. Press and release the TV mode key (TV must be in TV mode for this procedure). The LED will blink, and stay off for the 5 second period then blink once more to indicate volume toggle acceptance. [. . . ]