User manual MARMITEK TLV9600

[. . . ] Read carefully through this manual to familiarize yourself with this high-quality Time Lapse VCR. â· Make sure the rating of your household electricity supply matches that shown on the back of the Time Lapse VCR. â· During the power off, the unit is always connected to the mains. Unplug the unit from the wall outlet if it is not to be used for several days or more. [. . . ] (NTSC) Press the SET - (or +) button to set the day month (ex : 04), then press the SHIFT button. You can select the language -English, French, Spanish or Germanwhich is more convenient for you. The items for which "YES" is set are recorded. The items for which "NO" is set at step 6 above are not recorded. If you don't want to record the recording speed, counter, title, time, date etc, press the DISPLAY button, then start recording. A tape recorded on this VCR cannot be played back on another make of time lapse VCR. During recording, the Menu button will not function (the menu cannot be accessed). If you playback the recorded part where recording check was performed, noise may appear. â· If you change the recording speed during recording, noise or missing signal may result. During pause, the image appears on-screen but it is not recorded. â· If a recording pause continues for 5 minutes or more, the VCR will go into stop mode to avoid damage to the tape. There are two program timer recording methods, daily recording or recording on certain days of multiple weeks (weekly recording). Example 1 : To record on every Thursday from 10 : 00 to 18 : 00 , in 18-hour mode (recording speed) 1 Make sure that the set date and time are correct. 2 Load a cassette tape with erasure prevention tab in place. 3 Press the MENU, SHIFT button twice to move the arrow mark ( ) located on the "REC Mode Set", SHIFT button to select "Timer Program Set", SHIFT button to display the "TIMER PROGRAM SET(1)" menu. The cursor is moved to the recording start hour position. The cursor is moved to the recording stop hour position. The cursor is moved to the recording speed position. If the set stop time is earlier than or the same time as the set start time, the VCR will consider the stop time to be the following day. Repeat steps 4 to 11 to program timer recordings for other days of the week. END : Records until the tape end is reached when there is alarm trigger input. The maximum display number of alarm triggers is "35", at the next alarm recording the counter will indicate "00". [. . . ] â· If any problem is discovered during the inspection, unplug the power cord and consult your dealer. The following table provides a recommended guide on when to contact a service representative for maintenance. wARNING Do cleaning and lubricating from time to time even if the deck is not used. : Check and replace parts if necessary v : Replacement If the unit does not operate normally when you follow the instructions indicated in the manual, please refer to the table below. [. . . ]