User manual MARTIN AUDIO BX2

[. . . ] 16 After Sales Service Installation instructions 2 Warning and Safety instructions Read these Operating Instructions carefully before installing or using the Ventilation System. This appliance is intended for residential use only. Use the appliance only for its intended purpose. The manufacturer cannot be held responsible for damages caused by improper use of the hood. This appliance complies with current safety requirements. [. . . ] ­ A time of 20 hours should be programmed in kitchens with frequent pan or deep frying. ­ A time of 20 hours should also be programmed if the kitchen is only used occasionally. Otherwise grease which has accumulated over a long period of time will harden on the filters making cleaning more difficult. The indicator for the grease filter and one of the pm indicators will flash. The lit pm indicator shows the programmed time: 1st indicator from the left 2nd indicator from the left 3rd indicator from the left 4th indicator from the left = = = = 20 hours 30 hours 40 hours 50 hours. ^ Use the p or m button to select the desired time. ^ Press the On/Off button to turn off the fan. ^ Store the selection by pressing the grease filter button. ^ Press the Delayed Shut Down and grease filter buttons at the same time. If the procedure is not stored within 4 minutes of programming, the hood will automatically default to the "old" data. 12 Cleaning and Care Before cleaning or servicing the hood, disconnect it from the power supply by either removing the fuse, unplugging it from the outlet or manually "tripping" the circuit breaker. Stainless steel Stainless steel surfaces can be cleaned using a non-abrasive stainless steel cleaner. To help prevent resoiling, a conditioner for stainless steel can also be used. Stainless steel colored controls These controls may become discolored or damaged if not cleaned regularly. Do not use a stainless steel cleaner on these controls. Cleaning the casing Warning: Never use abrasive cleaners, scouring pads, steel wool or caustic (oven) cleaners on the hood. ^ All external surfaces and controls can be cleaned with warm water and liquid dish soap applied with a soft sponge. Do not use too much water when cleaning the controls. Water could penetrate into the electronics and cause damage. g Lower retaining plate A secures the canopy and the motor assembly. 2 M 6 locking nuts for securing the motor assembly. 2 screws 5 x 60 mm 4 screws 3. 9 x 7. 5 mm for securing the chimney and the chimney extension. CAUTION: During the installation process, please be careful of sharp edges that can cause harm. 23 Plywood backing The majority of the weight of the installed ventilation system will be supported by retaining plate A. It must be firmly attached to the stud framing behind the drywall. If studs are not available in the required locations, a plywood backing (min. 1/2" (13 mm) thick) spanning at least two studs must be installed. Failure to adequately support the weight as stated may result in the ventilation system falling off the wall, causing personal injury and property damage. ^ Hold retaining plate A against the wall so that the marks are visible through the holes of the plate (see "Installation / Retaining plate A"). Draw a line around the plate's perimeter, then set aside the plate. ^ Make a cutting line 3" (76 mm) above and 3" (76 mm) below the outline of plate "A". ^ Find the studs to the left and right of the mounting location by tapping the wall or using a stud finder. [. . . ] ^ Remove the protective foil from the canopy. If the chimney is not tall enough an optional chimney extension can be ordered. See "Appliance dimensions". ^ Remove the protective foil from the chimney. ^ Pull the chimney apart slightly and slide it over the chimney extension. [. . . ]