User manual MARTIN AUDIO C10.1C

[. . . ] After unpacking the system, examine it carefully for any signs of transit damage and inform your dealer if any such damage is found. It is suggested that you retain the original packaging so that the system can be repacked at a future date if necessary. [. . . ] These ceiling loudspeakers must be attached to a secure part of the building. 5 All material © 2007. Subject to change without notice. The subwoofer grille may be positioned so that it visually replaces a ceiling tile in a suspended ceiling but, we repeat - the subwoofer must not rely on the suspended ceiling structure for its support. Hint: It is easier to install your CS10 above a suspended ceiling structure if you temporarily remove surrounding ceiling tiles for better access and light. We must repeat; threaded rods or eyebolts must be permanently attached to the brackets provided using aircraft style locking nuts so that they cannot loosen under vibration. Do not simply hang this product from "hooks" as it could escape from them when driven with low frequency signals at high volume. If height adjustment is required, we recommend that you use locking adjustment nuts either side of the three brackets or turnbuckles (200Kg rating) between the building structure and the CS10 brackets. Anti-vibration gasket strip (supplied) may be placed around the edge of the grille for a snug fit without vibration. Connections Amplifier power input is via a 4-pin rising clamp plug providing + and ­ Inputs and + and ­ Loop Through connections. The CS10 input and loop connector must be fireproofed using the steel cover and screws provided. This cover has a 19mm (0. 75") knockout and a clamped cable entry. 6 All material © 2007. Subject to change without notice. C10. 1R and C10. 1C full-range ceiling loudspeakers Introduction Martin Audio C10. 1R (rectangular) and C10. 1C (circular) ceiling loudspeakers have been designed for high ceilings or where greater SPL is required. Both models employ a proprietary 16ohm coaxial 10" (250mm) bass driver with a well damped, fire retardant, fibre cone and a through-the-pole firing 1" (25mm) compression driver. The C10. 1R and C10. 1C are designed to fit enclosures manufactured by Atlas or Lowell. The C10. 1R fits a rectangular enclosure whilst the C10. 1C fits a cylindrical enclosure. Nominal spacing for smooth broadband coverage The C10. 1R and C10. 1C have a very controlled 90º dispersion giving a nominal spacing of 2 x (ceiling height ­ 1. 4m (4'7")). C10. 1R specifications 7 All material © 2007. [. . . ] cannot be held responsible for defects caused by unauthorised modifications, improper use, negligence, exposure to inclement weather conditions, act of God or accident, or any use of this product that is not in accordance with the instructions provided by Martin Audio. Martin Audio is not liable for consequential damages. [. . . ]