User manual MARTIN MAC 700 PROFILE

[. . . ] MAC 700 Profile user manual Dimensions All measurements are expressed in millimeters 255 120° 120° 645 365 636 515 390 143 14° 30° Min. c/c 520 450 270° 270° 505 © 2005 Martin Professional A/S, Denmark. No part of this manual may be reproduced, in any form or by any means, without permission in writing from Martin Professional A/S, Denmark. 10 Tips for reliable data transmission . [. . . ] The shutter opens when the movement is complete. This function is available for pan and tilt on channel 30 (22 in basic mode) and for color, gobo selection, gobo movement and prism change on channel 31 (23 in basic mode). PERSONALITY OVERRIDES The pan/tilt speed channel provides tracking values that allow you to override the pan/tilt speed setting from the controller. The effects speed channel provides values for overriding the shortcuts setting for the color and gobo wheels. 18 MAC 700 Profile Optical configuration Color wheel The MAC 700 Profile features a color wheel with 8 interchangeable dichroic color filters and an open position. The illustration shows the filter positions as seen from the lens. Refer to the DMX protocol for filter colors. 1 2 3 4 9 8 7 6 5 Figure 7: Filter positions, seen from lamp To replace a color filter Note: Wear cotton gloves while handling color filters and use only genuine Martin filters. Disconnect the fixture from AC power and allow it to cool. Lock the head in the upside-down position (the indication TOP on the back of the head must be upside down) and remove the bottom cover. For best access, align the rotating gobo wheel so that the open position is above the color filter to be replaced (see arrow in Figure 8). Turn the color wheel to access the desired filter position. Press the filter forwards slightly to release it and then grasp it by the edges and remove. If your fingers are too large, protect the glass with a piece of paper that has been folded several times and grasp the filter with needle nose pliers. To insert a filter, slide it under the retention spring until it snaps into place. Replace the cover and unlock the head before applying power. Figure 8: Filter replacement Optical configuration 19 Gobos Gobo wheel 1 provides 6 rotating gobos; gobo wheel 2 provides 9 static gobos. The standard gobo configuration is shown in Figure 9. Five extra metal gobos are supplied with the fixture. All gobos are interchangeable with the following limitations: · On wheel 1, the gobo retention spring works with gobos up to 3 mm in thickness. Thicker gobos can be glued to the holder with a UV adhesive or Loctite 330 Multibond with Activator. · Gobo 3 on wheel 1 is glass, and must therefore be changed together with its holder. A spare gobo retention spring for use with a metal gobo is supplied with the product. · The maximum thickness for gobos on wheel 2 is 1. 1 mm (0. 043 inches). Gobo wheel 1: rotating gobos Gobo wheel 2: static gobos 7 6 1 8 9 10 1 2 5 2 7 4 5 3 6 4 3 Figure 9: Gobo wheels as seen from front lens CUSTOM GOBOS Martin can provide many additional gobos for the MAC 700 Profile. Gobos are interchangeable between MAC 500, MAC 550 and MAC 700 fixtures. [. . . ] 0. 5 mm aluminum GOBO ANIMATION WHEEL Outside diameter . 116 mm +0/-0. 25 mm Image outer diameter . 0. 5 mm aluminum or textured glass with magnet APPROVALS EU EMC. . EN 55 103-1, EN 55 015, EN 61 547 EU safety . [. . . ]