User manual MASTERCRAFT X-9 WAKEBOARD 2001

[. . . ] WARNING Use the attached specified power supply cord. If you use another power supply cord, it may cause interference with radio and television reception. DO NOT LOOK DIRECTLY INTO THE LENS WHEN THE PROJECTOR IS IN THE POWER ON MODE. CAUTION The attached power cord is to be used exclusively for this product. [. . . ] Select a setting you want to set. 0 0 0 Gamma Use this setting to set an optimal gamma value and modulation of lamp power. The level of brightness can be adjusted for subdued colors. Dynamic Select when viewing crisp, clear images in a brightly lit room or strong daylight. The level of brightness is adjusted to higher levels. Natural Select when viewing images of which colors are more faithfully reproduced. The level of brightness and vividness is adjusted to optimal levels. Detail Select when viewing images of which brightness should be kept relatively low, such as movies and music video clips. 5. Press the  or  button to select an item to be adjusted: Gain, Saturation or Hue. 6. Press the  or  button to adjust the item. To cancel the menu: 7. Press the MENU button. BrilliantColor™ Use this setting to make colors with medium brightness, such as yellow and the skin tone appear natural. Press the  button to decrease the value to lessen the effect. Press the  button to increase the value to heighten the effect. Adjust Clamp Position or Clamp Width in the Signal-User menu. Noise appears in the right or left half of the image. Adjust Shutter(LS) or Shutter(RS) in the SignalUser menu. Noise appears in the top or bottom part of the image. Adjust Shutter(U) or Shutter(L) in the Signal-User menu. 2. Press the  or  button to select a setting to adjust. 3. Adjust the selected setting by pressing the  or  button. To cancel the menu: 4. Press the MENU button. • Do not change the settings of the Signal menu for ordinary use. LPF (Progressive filter) You can select to enable or disable the LPF. Vertical or horizontal streaks may appear in the projected image, depending on the type of the DVD player, game console or computer in use. If this occurs, reduce noise by enabling the LPF. [. . . ] The protection circuit is working or the lamp is in an abnormal condition. POSSIBLE SOLUTION • Clean the vents. • Relocate the projector to a cooler place. Blinking orange Steady red Blinking green • Wait until the STATUS indicator goes out, then press the POWER button. • If the above solution is not effective, replace the lamp. Change with a new lamp if this problem recurs. Steady green Blinking green/red The lamp operation time exceeds the time elapsed until the lamp lifetime notice while the power is on. [. . . ]