User manual MATSONIC MS6261

[. . . ] MS6261 User's Manual ©Copyright 1999 All Rights Reserved Aladdin V, Version 1. 1 October 1999 The information in this document is subject to change without prior notice in order to improve reliability, design and function and does not represent a commitment on the part of the manufacturer. In no event will the manufacturer be liable for direct, indirect, special, incidental, or consequential damages arising out of the use or inability to use the product or documentation, even if advised of the possibility of such damages. This document contains proprietary information protected by copyright. No part of this manual may be reproduced by any mechanical, electronic, or other means in any form without prior written permission of the manufacturer. [. . . ] Choose Enabled (default) or Disabled. This option allows the enabling or disabling of the external cache memory. Choose Enabled (default) or Disabled. This option speeds up the Power On Self Test routine. Choose "A, C, SCSI"(default), or others. This option determines which drive to engage first for the operating system. Choose Enabled or Disabled (default). This option swaps floppy drive assignments when enabled. In the POST mode, BIOS will detect the track numbers of the Installed floppy disk driver. 40 tracks is for 360K type driver and 80 is for 720K, 1. 2M, and 1. 44M. This option activates the NumLock function at boot-up time. External Cache Quick Power On Self Test Boot Sequence Figure 3-3. Use one of the arrow keys to move between options and modify the selected options by using PgUp/PgDn/+/-keys. An explanation of the <F> keys follows: Swap Floppy Drive  "Help"gives options available for each item. These values are the values with which the user started the current session. Loads all options with the BIOS default values. Boot Up Floppy Seek Boot Up NumLock Status Boot Up System Speed Choose High (default) or Low. Gate A20 Option Loads all options with the Setup default values. This option allows the RAM to access the memory above 1MB by using the fast gate A20 line. Typematic Rate Setting Choose Enabled or Disabled (default). Enable this option to adjust the keystroke repeat rate. MS6261 User's Manual Typematic Rate (Chars/Sec) Range between 6 (default) and 30 characters per second. This option controls the speed of repeating keystrokes. MS6261 User's Manual C hipset Features Setup Chipset Features Setup changes the values of the chipset registers. These registers control the system options. Modification other than the default value should first have chipset knowledge. Run the Chipset Features Setup as follows: 1. Choose "CHIPSET FEATURES SETUP"from the Main Menu and a screen depicted in Figure 3-4 appears. Typematic Delay (Msec) Choose 250 (default), 500, 750, or 1000. This option sets the time interval for displaying the first and the second characters. Security Option Choose System or Setup (default). This option is used to prevent unauthorized system boot-up or use of BIOS Setup. PCI/VGP Palette Snoop This item is used to determine whether the MPEG ISA/VESA VGA Cards can work with PCI/VGA or not. Assign IRQ for VGA OS Select for DRAM > 64MB Report No FDD for Win95 Video BIOS Shadow Choose Enabled or Disabled (default). Enable this option when using the OS/2 system and the memory is over 64MB. [. . . ] Choose 378/IRQ7 (default), 278/IRQ5, 3BC/IRQ7, or Disabled. This item allows user to determine access onboard parallel port controller with which I/O address. Choose SPP (default), ECP/EPP, ECP, EPP/SPP. This item is used to select an operating mode for the onboard parallel (printer) port. [. . . ]