User manual MATSONIC MS7012D

[. . . ] Important Information Copyright This publication, including all photographs, illustrations and software, is protected under international copyright laws, with all rights reserved. Neither this manual, nor any of the material contained herein, may be reproduced without the express written consent of the manufacturer. Disclaimer The information in this document is subject to change without notice. The manufacturer makes no representations or warranties with respect to the contents hereof and specifically disclaims any implied warranties of merchantability or fitness for any particular purpose. [. . . ] WOL1: Wake on LAN If you have installed a network adapter (LAN adapter), you can use the cable provided with the card to plug into the WOL1 connector on the mainboard. When your system is in a power­saving mode, any traffic through the network automatically resume the system. You must enable this item using the Power Management page of the setup utility. See Chapter three for more information. WOL1 WOM1 WOM1: Wake on Modem If you have installed a fax/modem card, you can use the cable provided with the card to plug into the WOM1 connector on the mainboard. When your system is in a power­saving mode, any incoming calls to the modem automatically resume the system. You must enable this item using the Power Management page of the setup utility. See Chapter Three for more information. 36 Install Options and Extension Brackets This mainboard has a number of special connectors that allow you to add optional features to your system. You can install any of the following items: Fax/modem card option Infrared port Serial port extension bracket 24-bit digital audio extension bracket (SPDIF) TV-out extension bracket Fax/modem Card You must install the fax/modem card in order to use the built-in fax/modem. J8 The fax/modem card is supplied with this mainboard. Locate the J8 fax/modem connector on the mainboard. Remove the expansion slot blanking plate from the system chassis that is adjacent to the fax/modem connector. Install the fax/modem card on to the J8 connector as shown below. The RJ11 Line and Telephone sockets on the bracket are positioned in the expansion slot with the removed blanking plate. 37 Line and Tel RJ11 sockets Fax/modem card J8 fax/modem connector Serial Port Extension Bracket If you want to have a second external serial port available in your computer case, you must install a serial port extension bracket. COM2 1. 4. Locate the serial port connector COM2. Remove a blanking plate from a free expansion slot in the system chassis. Plug the cable from the serial port extension bracket into the COM2 connector on the mainboard. The port connected to COM2 is identified as COM2/4 Install the metal bracket into the expansion slot in the system chassis from which you removed the blanking plate. Secure the bracket by driving a screw through the slot in the top of the metal bracket into the system chassis. 38 Note: An IR port and a second serial port use the same resources, and they may use some of the resources required by a fax/modem card. If you have more than one of these items installed, you may not be able to use them at the same time. You can use the Peripherals page of the setup utility to switch resources between an IR port and a second serial port. TV-out Extension Bracket The TV-out extension bracket provides video out jacks (RCA and/or Svideo). You can use these jacks to connect your computer to a TV set or digital flat panel display. TV1 1. Remove a blanking plate from a free expansion slot in the system chassis. [. . . ] DOS Installation Log on to the DOSDRV folder and run the program INSTALL. EXE Windows 95/98 Installation Please specify the path to the CD-ROM\CMI8X38\AUDIO_ITE_GAME \W95-98\DRV\ when your system detects the installed audio system. To install the audio applications, log on to the W95-98 folder, and then log on to the APPS folder. Windows NT 4. 0 Installation Press the "Start" button. Move the highlight to "Settings" and select "Control Panel". [. . . ]