User manual MATSONIC MS7112C

[. . . ] Important Information Copyright This publication, including all photographs, illustrations and software, is protected under international copyright laws, with all rights reserved. Neither this manual, nor any of the material contained herein, may be reproduced without the express written consent of the manufacturer. Disclaimer The information in this document is subject to change without notice. The manufacturer makes no representations or warranties with respect to the contents hereof and specifically disclaims any implied warranties of merchantability or fitness for any particular purpose. [. . . ] If you have such a drive, you might be able to configure it by setting the MODE to Large. If you're not sure which MODE setting is required by your drive, set MODE to Auto and let the setup utility try to determine the mode automatically. Drive A and Drive B Default: None , None These items define the characteristics of any diskette drive attached to the system. You can connect one or two diskette drives. Floppy 3 Mode Support Default: Disabled Floppy 3 mode refers to a 3. 5" diskette with a capacity of 1. 2 MB. Floppy 3 mode is sometimes used in Japan. Video Default: EGA/VGA This item defines the video mode of the system. This mainboard has a built-in VGA graphics system so you must leave this item at the default value. Halt On Default: All Errors This item defines the operation of the system POST (Power On Self Test) routine. You can use this item to select which kind of errors in the POST are sufficient to halt the system. These items show how much memory is available on the system. They are automatically detected by the system so you cannot manually make changes to these items. BIOS Feature Setup Option This option displays a table of items which defines more advanced information about your system. You can make modifications to most of these items without introducing fatal errors to your system. 26 CPU Internal Core Speed Default: 350MHz This item should be installed with the rated internal core speed of the Pentium-II class processor that is installed in your system. The setup utility will then automatically configure the system with the correct host bus speed, and bus frequency multiplier. If you set this item to Manual, two new items will appear: CPU Host BUS Frequency and CPU Core:Bus Freq. You can use these two items to manually configure the mainboard for the speed of the processor. The values available in these two items will vary, according to the kind of Pentium-II processor that is installed. Note: Using the three items above, you can configure the mainboard so that it runs a processor faster than the rated clock speed. We strongly recommend that you do not overclock the processor. Overclocking can introduce excess heat, recurring instability, or even complete failure in your system. CPU Core Voltage Default: Default This item can be used to a set a core voltage for different kinds of processors. Leave this item at the default value and your system will automatically assign the correct voltage. CPU Clock Failed Reset Default: Disabled If this item is enabled, and your system crashes three times because you have overclocked the processor, this item will automatically adjust the speed of the processor to the system bus speed multiplied by two. 27 CIH Buster Protection Default: Enabled Anti-Virus Protection Default: Enabled When "CIH Buster Protection" item is enabled it provided some protection against viruses which try to destroy BIOS viruses (especially for CIH). When "Anti-Virus Protection" item is enabled it provides some protection against viruses which try to write to the boot sector and partition table of your hard disk drive. [. . . ] Select the Add button on the drivers sheet. Select the item "VIA Bus Master PCI IDE Driver" and click OK. Reboot the system. Installing the IRQ Routing Driver This driver is for Windows 95/98. This driver solves some issues regarding the IRQ assignment of PCI devices. [. . . ]