User manual MATSONIC MS7192SM

[. . . ] This publication, including all photographs, illustrations and software, is protected under international copyright laws, with all rights reserved. Neither this manual, nor any of the material contained herein, may be reproduced without the express written consent of the manufacturer. The information in this document is subject to change without notice. The manufacturer makes no representations or warranties with respect to the contents hereof and specifically disclaims any implied warranties of merchantability or fitness for any particular purpose. [. . . ] Plug the Fax/Modem DAA module into the J1 modem header. Remove the blanking plate adjacent to the Fax/Modem DAA module. 16 ! Line & Tel RJ11 Sockets Modem DAA Module Modem Header Optional Digital Audio Extension Bracket This bracket has two RCA jacks for digital audio in and digital audio out, and an auxiliary jack for a Stereo Line-in device. 1 SPDIF1 Stereo Line-in SPDIF In SPDIF Out Digital Audio Extension Bracket 1. On the mainboard, locate the SPDIF1 header for this bracket. Plug the cable from the bracket into the SPDIF1 header. In the system chassis, remove a blanking plate from one of the expansion slots and install the extension bracket in the slot. Use the screw that held the blanking plate in place to secure the extension bracket. 17 ! Optional Infrared Port The mainboard has an infrared header SIR1 so that you can install an optional serial infrared port. 1 SIR1 1. On the mainboard locate the infrared port header SIR1. Connect the ribbon cable from the port to the header SIR1 and then secure the port to an appropriate place in your system chassis. Install Other Devices Install and connect any other devices in the system following the steps below. FDD1 1 1 1 IDE1 IDE2 Floppy Disk Drive The mainboard ships with a floppy disk drive cable that can support one or two drives. Drives can be 3. 5" or 5. 25" wide, with capacities of 360K, 720K, 1. 2MB, 1. 44MB, or 2. 88MB. 18 ! Install your drives and supply power from the system power unit. Use the cable provided to connect the drives to the floppy disk drive header FDD1. IDE Devices IDE devices include hard disk drives, high-density diskette drives, and CD-ROM/DVD drives. The mainboard ships with an IDE cable that can support one or two IDE devices. If you connect two devices to a single cable, you must configure one of the drives as Master and one of the drives as Slave. The documentation of the IDE device will tell you how to configure for Master or Slave. Install the device(s) and supply power from the system power unit. Use the cable provided to connect the device(s) to the Primary IDE channel connector IDE1 on the mainboard. If you want to install more IDE devices, you can purchase a second IDE cable and connect one or two devices to the Secondary IDE channel connector IDE on the mainboard. If you have two devices on the cable, one must be Master and one must be Slave. Internal Sound Connections If you have installed a CD-ROM drive or a DVD drive, you can connect the sound output of the drive to the built-in sound system. [. . . ] When the Save and Exit dialog box appears, press Y to save and exit, or press N to return to the setup main menu. Exit Without Saving Highlight this item and press Enter to discard any changes that you have made in the setup utility and exit the setup program. When the Exit Without Saving dialog box appears, press Y to discard changes and exit, or press N to return to the setup main menu. 36 Chapter 4 Software & Applications Introduction The support software CD-ROM that is included in the mainboard package contains all the drivers and utility programs needed to properly run our products. Please check all the README files for the latest information on installing and using the software. Using the PCI Sound Application 1. Before you install the PCI Sound drivers, make sure your Operating System has been installed, otherwise the PCI Sound might be detected as "Other device" by the device manager of your OS. [. . . ]