User manual MATSONIC MS7381SGM

[. . . ] This publication, including all photographs, illustrations and software, is protected under international copyright laws, with all rights reserved. Neither this manual, nor any of the material contained herein, may be reproduced without the express written consent of the manufacturer. The information in this document is subject to change without notice. The manufacturer makes no representations or warranties with respect to the contents hereof and specifically disclaims any implied warranties of merchantability or fitness for any particular purpose. [. . . ] If you have an ATAPI device with removable media (e. g. Use these items to set the size and capacity of the floppy diskette drive(s) installed in the system. Floppy Drive A Floppy Drive B 29 ! Advanced Setup Page Use this page to set more advanced information about your system. Making changes can affect the operation of your computer. Share Memory Size Trend ChipAway Virus 1st Boot Device 2nd Boot Device Try Other Boot Device S. M. A. R. T. for Hard Disks BootUp NumLock Floppy Drive Swap This item lets you allocate a portion of the main memory for use by the onboard VGA system. This mainboard has built-in virus protection in the firmware. Use this item to enable or disable the built-in virus protection. Use these two items to determine the order and priority that your computer follows to load an operating system at start-up time. If you enable this item, the system will also search for other boot devices if it fails to find an operating system from the first two locations. Enable this item if your hard disk(s) supports SMART (Self-Monitoring, Analysis and Reporting Technology). This items determines if the Num Lock key is active or inactive at system start-up time. If you have two diskette drives installed and you enable this item, drive A becomes drive B and drive B becomes drive A. 30 ! Floppy Drive Seek Password Check If you enable this item, your system will check the diskette drives at start up time. Disable this item unless you are using an old 360K diskette drive. If you have installed a password on your system, use this item to determine if the password is required to enter the setup utility (Setup) or required at start-up time and to enter the setup utility (Always). Enable this item if you are booting the OS/2 operating system and you have more than 64MB of memory installed. Leave this item enabled since all the processors that can be installed on this board have internal cache memory. If you enable this item, a segment of the system BIOS will be cached to main memory for faster execution. This item determines the speed of the installed SDRAM main memory. We recommend that you leave this item at the default value. This item determines the operation of the memory refresh timing. We recommend that you leave this item at the default value. [. . . ] At the next dialog box, type in the new password, or just press Enter to disable password protection. Exit Highlight this item and press Enter to save the changes that you have made in the setup utility and exit the setup program. When the Save and Exit dialog box appears, press Y to save and exit, or press N to exit without saving. 39 Chapter 4 Software & Applications Introduction The support software CD-ROM that is included in the mainboard package contains all the drivers and utility programs needed to properly run our products. Please check all the README files for the latest information on installing and using the software. Using the PCI Sound Application 1. Before you install the PCI Sound drivers, make sure your Operating System has been installed, otherwise the PCI Sound might be detected as "Other device" by the device manager of your OS. [. . . ]