User manual MATSUI 1409R

[. . . ] Interference ­ Do not place your television near appliances which may cause electromagnetic interference (i. e. If you do, it may adversely affect the working of the unit, causing the picture or sound to distort. place your television on a flat level surface avoiding anywhere which may be subject to strong vibration. Batteries ­ Batteries are easily swallowed by young children. [. . . ] Press PROG/PAGE / to select the programme number that you want this channel to be stored in. For example if the TV has automatically stored a BBC2 programme in channel number 6, you will need to press ENTER once and change the channel allocation number using PROG/PAGE / to 2. The picture settings have been adjusted by the factory under optimum signal reception conditions, however conditions may not be the same in your area. After turning on your television, allow it to warm up for a few minutes before making any adjustments. Should you wish to reset picture controls back to factory settings press NORMAL The sleep function allows you to automatically switch your television into standby after a preset amount of time (up to 120 minutes). In addition should you fall asleep or leave your TV unattended it will automatically switch into standby 15 minutes after the end of transmissions. 1 Inserting batteries into the Remote Control Press PROG/PAGE / to highlight auto. This will start the automatic tuning process. This process will take a few minutes to complete. When the programme on the screen stops changing and the sound comes on, the tuning process is complete. Press MENU twice to clear the display. Press MENU on your remote control. Press PROG/PAGE / on your remote control to highlight picture (indicated by a flashing green square). Press ENTER to view brightness, contrast, colour or sharpness on screen displays. Press VOL + or - to adjust the levels. To set the sleep timer press SLEEP. The display will clear in five seconds and your television will switch off automatically after 120 minutes. Repeated presses of SLEEP will decrease the sleep timer in 10 minute intervals from 120 minutes to 10 minutes. When you have set the sleep timer your TV will return to a normal picture and automatically switch off after the preset sleep time. To cancel the sleep timer set the sleep timer to 0. The display will clear in five seconds and your television will not switch off automatically. Since each programme may be picked up by your TV on more than one frequency the auto tune process will probably store more than one of each channel. For example there may be three BBC 2's. This means that once the automatic tuning process is complete you will need to allocate a channel number to the programmes with the clearest reception. To do this go to the next step - Sorting Channels. . . (If no channel is allocated, the on screen display will disappear after 1 minute. ) Press MENU three times to remove the tuning menu from the screen. The channel will now have changed position. Pictures appear sharpest in the daytime by increasing the contrast. In the evening (when surroundings are darker) the sharpest picture can be obtained by reducing the contrast. Press MENU twice to remove the picture menu. If you do not make an adjustment within 1 minute the menu will disappear. 9 Setting your security code Fault finding guide In an effort to fight crime, we have equipped your TV with security protection. [. . . ] Try using an aerial booster to improve the quality of broadcast signal. Replace batteries. Colour control is not adjusted. Remote control does not work or operates erratically. . 14" (32 cm visible) measured diagonally Colour system . [. . . ]