User manual MAXDATA 110T

[. . . ] User Manual Notebook i Notice The information in this user`s manual is subject to change without notice. THE MANUFACTURER OR RESELLER SHALL NOT BE LIABLE FOR ERRORS OR OMISSIONS CONTAINED IN THIS MANUAL AND SHALL NOT BE LIABLE FOR ANY CONSEQUENTIAL DAMAGES, WHICH MAY RESULT FROM THE PERFORMANCE OR USE OF THIS MANUAL. The information in this user`s manual is protected by copyright laws. No part of this manual may be photocopied or reproduced in any form without prior written authorization from the copyright owners. [. . . ] Using a small blade to press the latch A downward. The keyboard should pop up slightly over the latch. If the keyboard does not pop up, try to gently lift it up just over the latch. Repeat the step for the other keyboard latches. Carefully lift up the bottom edge of the keyboard and the following is revealed. 4-7 USER`S MANUAL PCB Connector Slot Original Memory Socket Fixing Screws DIMM Module Expansion Memory Socket Latch A Latch B Latch C Flexible PCB (The bridge between keyboard and the mainboard. ) Keyboard Illustration 4-4 Note: Your notebook has been tested with a wide range of DIMM on the market. However, not all memory modules are compatible. Check with your notebook vendor for a list of compatible DIMM for your notebook. 7. The memory socket is now revealed as the shown illustration 4-4. Press out on the latches located on both edges of the socket at the same time. The DIMM should pop up to an angle of 30 degree. 4-8 Section 4 UPGRADING YOUR NOTEBOOK 9. Pull the DIMM module out of the memory socket. Be sure to reserve the DIMM for the future use. Install the DIMM module into the memory socket. The DIMM will only fit in one orientation. Slide the DIMM at an angle of approximately 30 degrees into the empty memory socket. Then press it firmly so that the contact edge is driven into the receiving socket. Note: Notice the notches on the DIMM. The notches should fit nicely with the socket. Notch Illustration 4-6 DIMM Module Memory Socket 11. Pivot the DIMM until the latches on both sides of the socket snap into place. Put the keyboard back to its original face-up position. Be aware of the flexible PCB connected to the keyboard. The keyboard should now be locked by the spring-loaded latches. You have just completed the memory upgrade. 4-9 USER`S MANUAL Installing the DIMM Module In The Expansion Socket To remove the memory module, do the following: 1. [. . . ] Entsorgung gebrauchter Batterien navh Angaben des Herstellers. n n n n CAUTION: MODEL 340 FOR USE WITH POWER SUPPLY MODEL LSE9802A2060 ATTENTION: MODEL 340, POUR UTILISER AVEC LE MODELE LSE9802A2060 C-4 Appendix C AGENCY REGULATORY NOTICES Laser Safety The CD-ROM drive used with this notebook are certified as a Class 1 laser device according to the U. S. Department of Health and Human Services (DHHS) Radiation Performance Standard and International Standards IEC 825 / IEC 825-1 (EN60825 / EN60825-1). The device is not considered harmful, but the following precautions are recommended: n Do not open the unit. [. . . ]