User manual MAXDATA 660T

[. . . ] This is a supplement, not a substitute for the expanded Service Manual. All references are to the accompanying CD-ROM, Device Drivers and Tools which contains the expanded Service Manual (in Adobe Acrobat format), drivers, and special tools for your notebook computer. If you plan on using another operating system, not covered in these publications, please If they aren`t, or if you need to reconfigure (or reinstall) portions of the system, refer to the expanded Service Manual on the Device Drivers and Tools CD-ROM This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. [. . . ] If you discover damaged or missing items, please contact your retailer. Modem Cable In case you have to ship your notebook for servicing or upgrading, always use the original packaging. Therefore do not throw the original packaging away. Before you use the notebook the first time, please take some time to get accustomed with your note-book. shift the cover latch (1) to the right and open the display. Cover latch LED Power indicators: Power Accu New mail has arrived Figure 1 LCD- Display LED Power Indicators Speakers Three hot-key buttons LED status indicators Harddisc Numlock Capslock Scroll - Lock Power button (A short pressing of this button - less than 1sec. Your Notebook comes with a partially charged battery. Take the new battery from its wrapping and insert it into the notebook as shown in figure 3, 4 and 5. Remove the palm rest by applying gentle upward pressure with your fingers close to the area around the left Alt key, and the right Ctrl key. Slide the palm rest back in to place, applying a slight downward pressure to the left and the right side (see Figure 5) in order to snap it gently back in to place. The Notebook can be operated by battery or by power supply. The initial use will be by power supply, as the battery is ony partially loaded for shipping. A wrong power supply can damage your notebook. The notebook comes with an AC power cord and a universal, autoswitching power adapter. You can use the adapter anywhere the voltage is steady, between 100 and 240 volts. When the adapter is connected to a power source and then to the computer, the Power icon lights up to indicate the system is receiving AC power. Plug the power cord to the power adapter. Now you are ready to begin using your new notebook computer. To turn it on simply press the power button in the top right of the front panel. When the computer is turned on, the Power Button can also be used as a Standby/ Hibernate/Shutdown hotkey button if pressed less than 4 seconds (pressing and holding the Power Button for longer than this will shut the computer down) and appropriately configured in the OS Control Panel (Power Management or Power Options). Please note that you should always shut your computer down by choosing the Shut Down command from the Start menu in Windows. If the Ctrl + Alt + Del key combination doesn't work when the system "hangs", press the power button for 4 seconds to force the system to turn itself off. [. . . ] O o o Check the power bay, make sure the battery is present and seated properly. Make sure theres nothing interfering with the battery contacts. Plug in the AC power source and allow the system to recharge the battery (if present). If the computer doesnt start up immediately, turn it off then on again Press the Fn +F4 key combination, or press the On/Off switch if no LEDs are lit O As a last resort, since you will lose any unsaved data, try to reboot the system or if that doesnt work, turn the computer off and on again. [. . . ]