User manual MAXDATA 710

[. . . ] User`s Manual - Multimedia Notebook Computer 37 38 TABLE OF CONTENTS Table of Contents Notice Regulatory Information Usage & References Federal Communications Commission Statement: FCC Sound pressure level Note for the user: CD- ROM - Drive: Take back guarantee Important safety instructions Item Checklist The preparation Inserting the Battery Power supply Hardware Turning on the computer The Finger Print Sensor Power Management Intel ® SpeedStep ® A Short tour around your system Left and right side Rear and Bottom view Power/ Status indicators Key combinations The Launch Keys The Keyboard The Touchpad The CD - device The PC - Card - Slot Data / Fax Modem Appendix A - Specifications Appendix B - Troubleshooting 39 41 41 41 42 42 42 43 43 44 46 47 48 49 50 51 53 54 55 55 56 57 58 59 60 61 62 62 63 64 67 39 40 NOTICE The company reserves the right to revise this publication or to change its contents without notice. Information contained herein is for reference only and does not constitute a commitment on the part of the manufacturer or any subsequent vendor. They assume no responsibility or liability for any errors or inaccuracies that may appear in this publication nor are they in anyway responsible for any loss or damage resulting from the use (or misuse) of this publication. This publication and any accompanying software may not, in whole or in part, be reproduced, translated, transmitted or reduced to any machine readable form without prior consent from the vendor, manufacturer or creators of this publication, except for copies kept by the user for backup purposes. [. . . ] When the adapter is connected to a power source and then to the computer, the Power icon lights up to indicate the system is receiving AC power. Plug the power cord to the power adapter. Plug the power adapter to the DC IN socket on the computer´s rear panel. Plug the power cord into a wall outlet. WARNING The Power Supply contains no servicable parts DANGER!!UNDER NO CIRCUMSTANCE OPEN THE POWER SUPPLY!DANGER!! WARNING Figure 4 49 THE PREPARATION TURNING ON THE COMPUTER Now you are ready to begin using your new notebook computer. To turn it on simply press the power button in the top right of the front panel. When the computer is turned on, the Power Button can also be used as a Standby/ Hibernate/Shutdown hotkey button if pressed less than 4 seconds (pressing and holding the Power Button for longer than this will shut the computer down) and appropriately configured in the OS Control Panel (Power Management or Power Options). Figure 5 Shutdown Please note that you should always shut your computer down by choosing the Shut Down command from the Start menu in Windows. This will help prevent hard disk or system problems. Forced Off If the Ctrl + Alt + Del key combination doesn't work when the system "hangs", press the power button for 4 seconds to force the system to turn itself off. 50 THE PREPARATION THE FINGER PRINT SENSOR Your system is equipped with an intelligent User- Identify - System (Finger Print Sensor). This sensor is not active by default and must be activated in the BIOS-Settings, if desired. Figure 6 First Step : Enable Fingerprint 1. Turn on the system and push F2 button enter BIOS Setup Screen. Use Up and Down button to select , , System Security , , . Using the Full Fingerprint Lay the finger down flat, lightly but firmly on the sensor. This results in minimal distortion of the skin. If the finger is pulled or pushed left or right, forward or back, the image is distorted and fingerprint quality is reduced. Other problem If your fingers are too wet or dry, it impacts the sensor detecting. It may be necessary to let your finger have normally finger surface. If you still have problems properly verifying your fingerprint, you may need to re-register the same finger or another finger. 52 POWERMANAGEMENT POWERMANAGEMENT Your system is designed to work with both APM and the newer (and more effective) ACPI power management systems. PC Card Warning Do not remove or change the PC Card while the system is in Save to Disk Mode. The slot is turned off and any change in the system configuration may cause prob-lems when the computer comes back on. HARDWARE (BATTERY STATUS & WARNINGS ) After the POST finishes, the battery status LED in-dicates the battery´s charge level. When the battery is low, this icon flashes. [. . . ] · Click <Apply> to save this setting. · Click <OK> to leave the menues. You can close the Control Panel now ATTENTION Warning: This modem port is not compatible with digital phone lines (ISDN). Plugging this modem into a digital phone line will damage the modem. Abbildung 17 63 APPENDIX A - SPECIFICATIONS Microprocessor Memory · · · · Intel® PentiumTM III SpeedStep with 512/256K level 2 cache Main memory expandable to 1 GB Two 144-pin SoDIMM sockets SDRAM (Synchronous Dynamic Random Access Memory) 512 KB Flash ROM BIOS Data storage · · One high-capacity, Enhanced-IDE hard disk One 5. 25-inch internal optical drive Display and video · · · · 14. 1"/15" Thin Film Transistor (TFT) XGA/SXGA/UXGA LCD 1024x768 16M up to 1600x1200 16M colors for UXGA Simultaneous LCD and CRT display Dual display support Audio · · · · · 16-bit stereo audio 3-dimensional sound with built-in wavetable synthesizer Dual speakers Sound Blaster Pro- and Windows Sound System-compatible Separate audio ports for line-out, line-in devices Keyboard and pointing device · · 84-/85-/88-key Windows keyboard Ergonomically-centered touchpad pointing device 64 APPENDIX A - SPECIFICATIONS I/O ports · · · · · · · · · · · · · · · One type II/I CardBus PC Card slot One RJ-11 phone jack One RJ-45 network jack (Ethernet 10/100) One DC-in jack One parallel port (ECP/EPP compliant) One 100-pin port replicator connector One external monitor port (DDC 2. 0-compliant) One keyboard/mouse port (PS/2-compatible) One audio line-in jack One audio line-out jack Two USB ports One IEEE 1394 port Ethernet 2. 8 kg (5. 5 lbs) 323x 266 x 32. 9 mm Weight and dimensions Temperature · · Operating: 10°C ~ 35°C Non-operating: -20°C ~ 60°C Humidity (non-condensing) · · Operating: 20% ~ 80% RH Non-operating: 20% ~ 80% RH System · Windows operating system: Windows 98 SE, Windows 2000 and Windows XP Battery pack · · 37-WattHour Li-Ion battery pack 2-hour rapid charge/5-hour charge-in-use 65 APPENDIX A - SPECIFICATIONS AC adapter · · 65-Watt Auto sensing 100~240Vac, 50~60Hz Options · · · · · · · · · · 128/256/512 MB SDRAM memory upgrade module PS/2 Y-cable Additional AC adapter Secondary battery (swappable with the optical drive media bay) Numeric keypad Swappable optical module upgrade USB-to-Serial port Easy replicator External USB FDD Remote control module 66 APPENDIX B - TROUBLESHOOTING TROUBLESHOOTING If something goes wrong with your system, check here before you panic. [. . . ]