User manual MAXDATA P7200 SYSTEM

[. . . ] MAXDATA PLATINUM 7200 Server Product Guide MAXDATA PLATINUM 7200 Server 1 2 Contents Contents 1 Important Safety Information . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 7 Important Safety Information. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 7 Intended Application Uses . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 7 Safety Instructions and Information. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] · Modem Init String: the initialization string for the modem. This string is sent every time the EMP initializes. The maximum length for the string is determined at runtime from firmware. You will be notified if the string is truncated. Following a save, the actual string saved is displayed in the edit box. Click Close to return to the PEM window. Select the Enable PEP check box. 24 System Management 9. In the Blackout Period box, enter the minimum time, in minutes, between successive pages. The valid range is [0 - 255] where 0 disables the blackout period. Setting a blackout period can save you from being flooded with repeat pages. After you receive a PEP page, no additional pages are sent by PEP for the duration of the blackout period. In the Paging String box, enter the phone number to dial for the page and the message you want sent with the page. The maximum length for the paging string is determined at runtime from firmware. You will be notified if the string is truncated. Following a save, the actual string saved is displayed in the edit box. From the Options menu, choose Configure Event Actions. In the Platform Event Paging Actions window, move the events that you want to generate an alert to the Enabled column and move all other events to the disabled column using the following buttons: >>: Moves all events from the enabled list to the disabled list. >: <: Moves the selected event from the enabled list to the disabled list. Moves the selected event from the disabled list to enabled the list. <<: Moves all events from the disabled list to the enabled list. Click Close to return to the PEP Configuration window. To send a test page to verify that you have correctly configured PEP, from the Options menu, choose Send Alert. Click Close to return to the Platform Event Manager window. Setting Up LAN Alerts To set up the server to send alerts over the LAN: 1. [. . . ] Pressing the power button or other wakeup event will restore the system state from the disk and resume normal operation. This assumes that no hardware changes have been made to the system while it was off. s5: Soft off: Only the RTC section of the CSB and the BMC are running in this state. No context is saved by the OS or hardware. · CAUTION The system is off only when the AC power cord is disconnected. Hyper-Threading Technology The server supports Intel® Hyper-Threading technology. [. . . ]