User manual MAXDATA PRO 7000X

[. . . ] 54 Additional safety notes for units with wireless LAN . The company reserves the right to make unadvertised modifications to this document. Information contained in this document is intended solely for reference purposes and in no way constitutes a basis for asserting obligations on the part of the manufacturer or vendor. Neither the manufacturer nor the vendor accept liability for any errors or inaccuracies that this document may contain. [. . . ] It is forbidden to use the unit outside of enclosed areas. A licence is required to use the unit in the open. For more detailed information about the procedure to be followed for this, please contact your provider. The following information was correct at January 2002. You can obtain current information from the appropriate authorities in your country (e. Radio network cards and adapters are designed in accordance with IEEE-Standard 802. 11b for use in the ISM frequency band (Industrial, Scientific, Medical) between 2. Because of the DSSSprocedure (Direct Sequence Spread Spectrum), each of the 11 usable radio channels takes up a width of 22 MHz; this means that up to three, independent channels are available (e. The following table lists the authorised channels in your country: The installation and use of an unit with Wireless LAN may only take place when in accordance with the instructions contained in the user documents. The user documents are included in the material supplied with the product. All alterations or modifications made to this unit which are not expressly authorised by the manufacturer may lead to cancellation of the right of the user to operate the unit. The manufacturer is not liable for radio disruptions during the reception of radio and television signals which are due to non-authorised alterations to the unit or to the exchange or connection of cables and accessories, where these are not in accordance with the recommendations of the manufacturer. It is the responsibility of the user to remove any interference which may arise as a result of any non-authorised alterations, or the addition or replacement of components. Neither the manufacturer nor his authorised dealer and wholesaler are liable for damages or breaches of legal regulations which result from an infringement of these guidelines. Before you begin installing your notebook, make sure that all components are present. If any item listed in the shipping contents is missing from your computer package, please contact your dealer immediately. Before first using the computer, make sure you are familiar with the individual components of your system. LCD display Status LEDs CD player controls Power button Quick launch keys TouchPad Built-in microphone Keys and scroll pad Hand rest Keyboard Loudspeaker This battery is only partially charged. Gently push the battery until it locks into place. Make sure that you allow the battery to charge for TWO hours if the computer is switched off, or for FOUR hours if the computer is switched on!It is absolutely essential that the first time you charge the battery you fully charge it!Do not unplug the notebook from the power adapter until the battery is fully charged. [. . . ] This means that all the data and drivers that the system requires are already on the hard disk. In case you erase and/or format your hard disk drive, the system drivers are stored on the Utility CD supplied with the computer. After reinstalling the operating system (for example, with the Recovery CD), this allows you to restore your notebook to a usable condition. It doesn't matter which order you complete the installation in. [. . . ]