User manual MAXDATA VISION 350M

[. . . ] Notebook Vision 350M Vision 450T i Notice The information in this user`s manual is subject to change without notice. THE MANUFACTURER OR RESELLER SHALL NOT BE LIABLE FOR ERRORS OR OMISSIONS CONTAINED IN THIS MANUAL AND SHALL NOT BE LIABLE FOR ANY CONSEQUENTIAL DAMAGES, WHICH MAY RESULT FROM THE PERFORMANCE OR USE OF THIS MANUAL. The information in this user`s manual is protected by copyright laws. No part of this manual may be photocopied or reproduced in any form without prior written authorization from the copyright owners. Copyright April, 2000 All rights reserved. Microsoft and Windows are registered trademarks of Microsoft Corporation. [. . . ] If the keyboard does not pop up, try to gently lift it up just over the latch. Repeat the step for the other keyboard latches. Carefully lift up the bottom edge of the keyboard and the following is revealed. 4-7 USER`S MANUAL PCB Connector Slot Original Memory Socket Fixing Screws DIMM Module Expansion Memory Socket Latch A Latch B Latch C Flexible PCB (The bridge between keyboard and the mainboard. ) Keyboard Illustration 4-4 Note: Your notebook has been tested with a wide range of DIMM on the market. However, not all memory modules are compatible. Check with your notebook vendor for a list of compatible DIMM for your notebook. 7. The memory socket is now revealed as the shown illustration 4-4. Press out on the latches located on both edges of the socket at the same time. The DIMM should pop up to an angle of 30 degree. 4-8 Section 4 UPGRADING YOUR NOTEBOOK 9. Pull the DIMM module out of the memory socket. Be sure to reserve the DIMM for the future use. Install the DIMM module into the memory socket. The DIMM will only fit in one orientation. Slide the DIMM at an angle of approximately 30 degrees into the empty memory socket. Then press it firmly so that the contact edge is driven into the receiving socket. Note: Notice the notches on the DIMM. The notches should fit nicely with the socket. Notch Illustration 4-6 DIMM Module Memory Socket 11. Pivot the DIMM until the latches on both sides of the socket snap into place. Put the keyboard back to its original face-up position. Be aware of the flexible PCB connected to the keyboard. The keyboard should now be locked by the spring-loaded latches. You have just completed the memory upgrade. 4-9 USER`S MANUAL Installing the DIMM Module In The Expansion Socket To remove the memory module, do the following: 1. Follow steps 1~7 in the above section, Installing the DIMM Module In The Memory Socket. Hold the extended memory module at a 30-degree angle and slide it into the empty momery socket. Notch DIMM Module Memory Socket 3. [. . . ] The device is not considered harmful, but the following precautions are recommended: n Do not open the unit. n Avoid direct exposure to the laser beam. n If the unit requires service, contact an authorized service center. n Ensure proper use by reading and following the instructions carefully. [. . . ]