User manual MAXI-COSI PRIORI XP

[. . . ] GB ³ Cover Belt clamp Belt guard door Red belt hooks Shell Belt clamping handle Belt yoke Base Belt tensioner µ User instruction sticker ¸ ECE hallmark ¹ Instruction manual Belt slots Belt pads Belt buckle Hook for securing buckle Adjuster belt Shell positioning handle Release button Shoulder belts seat belt system © Shoulder belt hooks (harness belt system) Dear parents Congratulations on the purchase of your Maxi-Cosi Priori XP. Safety, comfort and user-friendliness have at all times played an important role in the development of the Maxi-Cosi Priori XP. This product meets the most stringent safety regulations. Research shows that a high number of car safety seats are installed incorrectly. [. . . ] Release the adjusting handle in the desired position and push until you hear a distinct click. Before installing the Maxi-Cosi Priori XP, pull the seat towards you as far as possible (sleeping position) (05). Installing the Maxi-Cosi Priori XP Please read the "Seat Belt" section before installing the Maxi-Cosi Priori XP. ⷠPlace the Maxi-Cosi Priori XP on the car seat in the sleeping position (05). The handle will now visibly protrude from the base (06). The belt tensioner should no longer be positioned between the red belt hooks (07). ⷠThread the seat belt between the shell and the base. Make sure that the lap belt section of the seat belt is threaded between the red hooks and the belt tensioner (08). ⷠFasten the seat belt in the belt buckle of the car (08) and check to ensure the car seat belt is not twisted. ⷠThe lap belt should now run under the red seat belt hooks (09) and the shoulder belt should run from the car seat buckle directly diagonally upwards. Next, push the Maxi-Cosi Priori XP firmly into the car seat (11/2) whilst at the same time pulling the shoulder belt tight (11/3), so that the Maxi-Cosi Priori XP is securely in place. Now return the handle to its original position (click) making sure it rests against the base (12). the belt tensioner tightens the seat belt even further. The belt tensioner should now be positioned between both belt hooks on the lap belt (13). ⷠYou can now adjust the shell of the Maxi-Cosi Priori XP into the desired position. If the cover on your seat has Velcro on the side seam on the back (28), you can leave the entire belt system in place in the shell. You only need to open the Velcro and then follow the instructions for removing the cover. Loosen the shoulder belts by pressing the release button and pulling the shoulder belts towards you (14). Important: Do not pull on the belt pads when doing so. Position your child comfortably with his/her back against the shell (18) and make sure that there are no toys or other hard objects in the shell. ⷠSlide buckle tongue sections together and insert them into the buckle (19). Pull the shoulder belts tight (20/1) and pull the remaining slack out of the belt system by pulling the belts tight using the adjuster belt (20/2). [. . . ] this is easiest to do in the uppermost vertical section (31). Remove both belt hooks by pushing the tab on the back of the seat downwards (32). Pull the belts, belt pads, buckle sections and seat buckle through the openings in the cover. Important: Be careful when removing the cover around the edge of the release button (34). [. . . ]