User manual MAXTOR FIREBALL TM JUMPER SETTINGS ATA

[. . . ] Fireball TM Jumper Settings ATA Jumper Settings DS Stand alone Master to Slave Slave to Master ON ON OFF SP OFF OFF OFF CS OFF OFF OFF PK X X X X = PK is a Parking position. [. . . ] This is to provide for retention of the jumper in the event it is needed later. Jumper Locations The Fireball TM disk drive has only one location where user configurable jumpers are found. The jumper block for the Fireball TM is found on the disk drive printed circuit board. Using the jumper pins you can establish the drive Master/Slave configuration. 1 of 1 Fireball TM fireball_tm_jumper. pdf BIOS Settings The following BIOS parameters are provided for customers needing to manually configure the Quantum disk drive. Both base 2 and base 10 capacity values are displayed. Cylinders 1. 0 GB 1. 2 GB 1. 7 GB 2. 1 GB 2. 5 GB 3. 2 GB 3. 8 GB 2112 2484 3309 4092 4969 6232 7480 Heads 16 16 16 16 16 16 16 Sectors 63 63 63 63 63 63 63 Base 2 Capacity 1, 039 MB 1, 222 MB 1, 628 MB 2, 014 MB 2, 445 MB 3, 067 MB 3, 681 MB Base 10 Capacity 1, 089 MB 1, 281 MB 1, 707 MB 2, 111 MB 2, 564 MB 3, 216 MB 3, 860 MB Special Considerations Hard drives greater than 2. 1GB may need to be divided into multiple partitions / logical drives. [. . . ] The file systems supported by Windows-95, Windows-98 and Windows NT are not restricted to the 8. 4GB physical drive limit, but special BIOS support is required. SCSI Configuration Guide 2 of 2 Fireball TM fireball_tm_jumper. pdf Jumper Settings Drive Termination Enable Termination Disable Termination TE jumper on TE jumper off Set SCSI ID SCSI ID 0 1 2 3 4 5 6 7 A0 Off On Off On Off On Off On A1 Off Off On On Off Off On On A2 Off Off Off Off On On On On 3 of 3 [. . . ]