User manual MAXTOR MEDALIST 3230

[. . . ] . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Medalist 4340, Medalist 3230 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Medalist 2120, Medalist 1721 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Medalist 1010 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . ATA Interface Drives . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] Typical sound power (bels) 3. 7 4. 3 Maximum sound power (bels) 4. 1 4. 6 Mode Idle Read/Write 1. 10 Electromagnetic susceptibility The drive operates without errors when subjected to the following: Radiated noise* Electrostatic discharge* Magnetic field strength 3 volt/meter, 30 Hz to 1 GHz 10 KVolts 5 Gauss * Electrostatic discharge and radiated noise susceptibility are measured with the drive mounted in a representative computer system (mounted to a ground plane with earth grounding). Discharges are applied to the bezel or other external surfaces on the ground plane. 1. 11 Reliability Nonrecoverable read errors Mean time between failures 1 per 1014 bits read, max 300, 000 power-on hours (nominal power, 25°C ambient temperature) Medalist 4340, 3230, 2120, 1721 and 1010, Rev. A Contact start-stop cycles 15 40, 000 cycles (at nominal voltage and temperature, with 60 cycles per hour and a 50% duty cycle) None required Preventive maintenance 1. 12 Agency certification 1. 12. 1 Safety certification The drives are recognized in accordance with UL 1950 and CSA C22. 2 (950) and meet all applicable sections of IEC950 and EN 60950 as tested by TUV North America. 1. 12. 2 Electromagnetic Compatibility Hard drives that display the CE marking comply with European Union requirements specified in Electromagnetic Compatibility Directives. Testing is performed to standards EN50082-1 and EN55022-B. Seagate uses an independent laboratory to confirm compliance with the EC directives specified in the previous paragraph. Drives are tested in representative end-user systems. Although CE-marked Seagate drives comply with the directives when used in the test systems, we cannot guarantee that all systems will comply with the directives. The drive is designed for operation inside a properly designed enclosure, with properly shielded I/O cable (if necessary) and terminators on all unused I/O ports. Computer manufacturers and system integrators should confirm EMC compliance and provide CE marking for their products. 1. 12. 3 FCC verification These drives are intended to be contained solely within a personal computer or similar enclosure (not attached as an external device). As such, each drive is considered to be a subassembly even when it is individually marketed to the customer. As a subassembly, no Federal Communications Commission verification or certification of the device is required. has tested this device in enclosures as described above to ensure that the total assembly (enclosure, disc drive, motherboard, power supply, etc. ) does comply with the limits for a Class B computing device, pursuant to Subpart J, Part 15 of the FCC rules. Operation with noncertified assemblies is likely to result in interference to radio and television reception. 16 Medalist 4340, 3230, 2120, 1721 and 1010, Rev. This equipment generates and uses radio frequency energy and if not installed and used in strict accordance with the manufacturer's instructions, may cause interference to radio and television reception. This equipment is designed to provide reasonable protection against such interference in a residential installation. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause interference to radio or television, which can be determined by turning the equipment on and off, you are encouraged to try one or more of the following corrective measures: · Reorient the receiving antenna. · Move the device to one side or the other of the radio or TV. · Move the device farther away from the radio or TV. · Plug the computer into a different outlet so that the receiver and computer are on different branch outlets. If necessary, you should consult your dealer or an experienced radio/television technician for additional suggestions. You may find helpful the following booklet prepared by the Federal Communications Commission: How to Identify and Resolve Radio-Television Interference Problems. [. . . ] A 29 3. 2. 3 Set Features command This command controls the implementation of various features that the drive supports. When the drive receives this command, it sets BSY, checks the contents of the Features register, clears BSY and generates an interrupt. If the value in the register does not represent a feature that the drive supports, the command is aborted. Power-on default has the read look-ahead and write caching features enabled and 4 bytes of ECC. [. . . ]